Abstract:Aqua ammonia is thought to be a feasible new absorbent for CO2 capture in recent years because of its high CO2 removal efficiency,high loading capacity and the possibility of removing NOx and SOx simultaneously.The heat of reaction for aqua ammonia regeneration was considered as low as 26.88 kJ·(mol CO2)-1 before,which was much lower than 85 kJ·(mol CO2)-1 for MEA regeneration.Data from literature were collected and compared,and their reliability was analyzed in this work.It was found that both our theoretical estimation and experimental data disagreed with those from earlier economic analyses for aqua ammonia capture system.The experimental data in this paper also confirmed that the heat of absorption was about 60—70 kJ·(mol CO2)-1 and was seemingly independent of CO2 loading at a low temperature (35℃).The heat of absorption at a high temperature (80℃) was about 60 kJ·(mol CO2)-1 at the beginning,rose to a maximum of around 120 kJ·(mol CO2)-1 with increasing loading,and then decreased to 80 kJ·(mol CO2)-1 after a certain high loading value was reached.It was impossible to get heat of absorption as low as 26.88 kJ·(mol CO2)-1 according to the experimental data of CO2 in ammonium carbonate solutions.Therefore,aqua ammonia had advantage in energy saving,however the advantage of aqua ammonia over other amine solutions was not as obvious as expected.

Analysis on Regeneration Energy of NH3-based CO2 Capture with Equilibrium-based Simulation Method

A Comprehensive Model for Regeneration Process of CO 2 Capture Using Aqueous Ammonia Solution

On Reaction Models of Regeneration Process for NH3-Based CO2 Capture

Reaction Sensitivity Analysis of Regeneration Process of CO2 Capture Using Aqueous Ammonia

On Reaction Models of Regeneration Process for NH 3 -Based CO 2 Capture

Rate-based modelling of CO2 regeneration in ammonia based CO2 capture process

Process simulations of NH3 abatement system for large-scale CO2 capture using aqueous ammonia solution

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Performance Simulations of Mea/Nh3 Based Large-Scale Co2 Capture in Packed Columns under Different Flue Gas Parameters

Experimental Study on Regeneration Characteristic of CO2-rich Ammonia Solution and Absorption Characteristics of the Regenerative Solution

Heat requirement for regeneration of a CO_2 capture system using amine solutions

Rate based modeling of absorption and regeneration for CO2 capture by aqueous ammonia solution

Modeling Analysis of Energy Requirement in Aqueous Ammonia Based CO2 Capture Process

Intrinsic Insight of Energy-Efficiency Optimization for CO2 Capture by Amine-Based Solvent: Effect of Mass Transfer and Solvent Regeneration

Rate-Based Modeling Of Regeneration Process For Co2 Capture By Aqueous Ammonia Solution In A Pilot Plant At Munmorah Power Station

Experimental study on regeneration characteristic of C02-rich ammonia solution and absorption characteristics of the regenerative solution

Research on Heat Requirement of Aqua Ammonia Regeneration for CO2 Capture

Experimental And Rate-Based Modeling Study Of Co2 Capture By Aqueous Monoethanolamine

A novel process for capturing carbon dioxide using aqueous ammonia

Experimental Studies And Rate-Based Process Simulations Of Co2 Absorption With Aqueous Ammonia Solutions

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process