Abstract:Aqueous ammonia can be used to capture CO2 from flue gas of coal-fired power plant with quick reaction rate, high removal efficiency, and high loading capacity of CO2. It is thought to be a promising technology. However, the CO2 absorption rate, diffusion rate and VLE (Vapor liquid equilibrium) in aqueous ammonia have still been rarely researched. More research is necessary for these characters of ammonia solution as CO2 absorbent. The paper will focus on the fundamental characteristics of CO2 in aqueous ammonia. A series of tests were conducted in a semi-batch reactor that has been developed in this paper. CO2 removal efficiencies at different concentrations of aqueous ammonia have been studied in the similar operation conditions to compare their basic characters in the CO2 absorption process. And a small wetted wall column (WWC) with a contact area of about 41.45 cm(2) was also built for the study of the absorption rate, diffusion, and solubility of carbon dioxide in the aqueous solution. In the paper, reaction rate and overall gas transfer coefficient were studied. The concentration of ammonia ranges from 1, 5, 10 to 15. CO2 and N-2 are used to simulate the flue gas. The concentration of CO2 ranges from 5, 10, 15, to 20%. The reaction temperatures are 20 degrees C and 40 degrees C. It is indicated in this paper that the best concentration of aqueous ammonia should be selected from 5% to 10%. And aqueous ammonia has a high Flux in WWC, which is three times higher than that of MDEA+PZ, under the same condition. It is also found that K-G is appropriate to be used in the mass transfer process of the carbon dioxide absorption by aqueous ammonia. Alls of these experiments established foundation for the further study of CO2 removal by ammonia. (c) 2008 Elsevier Ltd. All rights reserved

Experimental Study on Regeneration Characteristic of CO2-rich Ammonia Solution and Absorption Characteristics of the Regenerative Solution

Experimental study on regeneration characteristic of C02-rich ammonia solution and absorption characteristics of the regenerative solution

Study on CO2 Absorption-Mineralization Characteristics of Mixed Amine Solution Coupled with CaO and Key Influencing Factors in Mineralization Process

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Experimental Study on Carbon Dioxide Absorption by Aqueous Ammonia with Nickel and Chromium Ions in Bubbling Tower at Low Temperatures

Experimental Study on CO2 Absorption and Regeneration of Aqueous Sodium Glycinate Solutions

Semi-batch experimental study on CO2 absorption characteristic of aqueous ammonia

A Novel Method to Recover Ammonia Loss in Ammonia‐based CO 2 Capture System: Ammonia Regeneration by Vacuum Membrane Distillation

Experimental Study of CO2 Regeneration from Ammonia Rich Solution by Membrane Vacuum Regeneration

Research on Heat Requirement of Aqua Ammonia Regeneration for CO2 Capture

Experimental Study on Co2 Absorption by Aqueous Ammonia Solution at Elevated Pressure to Enhance Co2 Absorption and Suppress Ammonia Vaporization

A Comprehensive Model for Regeneration Process of CO 2 Capture Using Aqueous Ammonia Solution

Effect of carbonized ammonia constituent on the crystallization process

Kinetics and mass transfer of carbon dioxide absorption into aqueous ammonia

Absorption of carbon dioxide in aqueous ammonia

Experimental Studies on Removal Capacity of Carbon Dioxide by a Packed Reactor and a Spray Column Using Aqueous Ammonia

A new technique of carbon capture by ammonia with the reinforced crystallization at low carbonized ratio and initial experimental research

Analysis on Regeneration Energy of NH3-based CO2 Capture with Equilibrium-based Simulation Method

Regenerative process analysis of the new carbon capture technique based on mixed absorbent

Study on Regenerative Process of the New Carbon Capture Technique Based on Antisolvent Crystallization to Strengthen Crystallization

Research progress of CO2 capture by using ammonia from flue gas of power plant