Abstract:Aqueous ammonia can be used to capture CO2 from flue gas of coal-fired power plant with quick reaction rate, high removal efficiency, and high loading capacity of CO2. It is thought to be a promising technology. However, the CO2 absorption rate, diffusion rate and VLE (Vapor liquid equilibrium) in aqueous ammonia have still been rarely researched. More research is necessary for these characters of ammonia solution as CO2 absorbent. The paper will focus on the fundamental characteristics of CO2 in aqueous ammonia. A series of tests were conducted in a semi-batch reactor that has been developed in this paper. CO2 removal efficiencies at different concentrations of aqueous ammonia have been studied in the similar operation conditions to compare their basic characters in the CO2 absorption process. And a small wetted wall column (WWC) with a contact area of about 41.45 cm(2) was also built for the study of the absorption rate, diffusion, and solubility of carbon dioxide in the aqueous solution. In the paper, reaction rate and overall gas transfer coefficient were studied. The concentration of ammonia ranges from 1, 5, 10 to 15. CO2 and N-2 are used to simulate the flue gas. The concentration of CO2 ranges from 5, 10, 15, to 20%. The reaction temperatures are 20 degrees C and 40 degrees C. It is indicated in this paper that the best concentration of aqueous ammonia should be selected from 5% to 10%. And aqueous ammonia has a high Flux in WWC, which is three times higher than that of MDEA+PZ, under the same condition. It is also found that K-G is appropriate to be used in the mass transfer process of the carbon dioxide absorption by aqueous ammonia. Alls of these experiments established foundation for the further study of CO2 removal by ammonia. (c) 2008 Elsevier Ltd. All rights reserved

Research progress of CO2 capture by using ammonia from flue gas of power plant

Experimental Research Of Co2 Removal By Ammonia Solutions From Flue Gas Of Coal-Fired Power Plant

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Kinetics and mass transfer of carbon dioxide absorption into aqueous ammonia

Experimental Study on Carbon Dioxide Absorption by Aqueous Ammonia with Nickel and Chromium Ions in Bubbling Tower at Low Temperatures

Absorption of carbon dioxide in aqueous ammonia

Carbon Dioxide Recovery From Flue Gases By Ammonia Scrubbing

Research Progress on Amine Absorbent for CO2 Capture from Flue Gas

Simulation of CO2 capture using ammonia scrubbing: A comparison with MEA scrubbing

Semi-batch experimental study on CO2 absorption characteristic of aqueous ammonia

Simultaneous Absorption of SO2 and CO2 from Flue Gas Using Aqueous Ammonia

Experimental Study and Numerical Simulation on CO2 Capture from Flue Gas Using Amine-Based Absorbent in Coal-Fired Power Plant

Research on Modern CO2 Absorption Process

Impact of SO2 on CO2 capture in coal-fired flue gas using aqueous ammonia

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

Experimental Study on Co2 Absorption by Aqueous Ammonia Solution at Elevated Pressure to Enhance Co2 Absorption and Suppress Ammonia Vaporization

Recovery of carbon dioxide by ammonia scrubbing in power plants

Experimental study on regeneration characteristic of C02-rich ammonia solution and absorption characteristics of the regenerative solution

The present situation, challenges, and prospects of the application of ammonia–coal co-firing technology in power plant boilers

Experimental Study on Regeneration Characteristic of CO2-rich Ammonia Solution and Absorption Characteristics of the Regenerative Solution

Technique Analyses and Research Progress of CO2 Separation from Flue Gas by Chemical Absorption