Abstract:Although ammonia-based CO2 capture has attracted global research attention, several inherent issues with this technology remain to-be resolved. To address these problems, a new design for carbon capture using ammonia is proposed on the basis of anti-solvent crystallization, also known as precipitation crystallization. The crystallization of a low carbonized absorbent was found to-be, enhanced in the crystallizer using an-anti-solvent process, which can maintain a high absorption rate and simultaneously prevent crystallization from occurring in the absorption tower. Energy consumption for sorbent regeneration is, reduced by regenerating the crystal product rather than the rich-solution. Energy-cascade utilization-is an effective way to improve the use of energy. In this work, steam was used to drive a heat pump that extracts energy from discharged flue gas from a wet flue gas desulfurization system in. a power plant to enablethe recovery of low-temperature residual energy; this energy can be used in the crystal regeneration process, thereby further reducing the energy required for regeneration. Aspen Plus (version 8.4) software was adopted:to simulate the flue gas condensation, heat-pump circulation, and steam drive'-subsystems. The simulation results showed that 10 heat pumps (6.04 MW) can meet the regeneration energy requirement of the CO, capture process in a 300 MW coal-fired unit and recycle 40.6 MW of low-temperature heat. The extraction steam requirement is low, which reduces the impact on power-generation.

Simulation of CO2 capture using ammonia scrubbing: A comparison with MEA scrubbing

Simulation of a CO_2 Capture System Using Amine Solutions for Selection of Absorbents

Experimental Study and Numerical Simulation on CO2 Capture from Flue Gas Using Amine-Based Absorbent in Coal-Fired Power Plant

Performance Simulations of Mea/Nh3 Based Large-Scale Co2 Capture in Packed Columns under Different Flue Gas Parameters

Experimental Research Of Co2 Removal By Ammonia Solutions From Flue Gas Of Coal-Fired Power Plant

Simulation and Analysis of Carbon Dioxide Capture Process with Split Flow Modification Using MDEA/PZ Blend Solution in a Coal-fired Power Plant

Simultaneous Absorption of SO2 and CO2 from Flue Gas Using Aqueous Ammonia

Research progress of CO2 capture by using ammonia from flue gas of power plant

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

Process simulations of large-scale CO2 capture in coal-fired power plants using aqueous ammonia solution

Simulation and pilot plant measurement for CO2 absorption with mixed amines

Life Cycle Emissions of Greenhouse Gas for Ammonia Scrubbing Technology

Pilot-Scale Experimental Study on the CO2 Capture Process with Existing of SO2: Degradation, Reaction Rate, and Mass Transfer

Carbon Dioxide Recovery From Flue Gases By Ammonia Scrubbing

Semi-batch experimental study on CO2 absorption characteristic of aqueous ammonia

Process simulations of NH3 abatement system for large-scale CO2 capture using aqueous ammonia solution

Simulation Optimization of A New Ammonia-Based Carbon Capture Process Coupled with Low-Temperature Waste Heat Utilization

Removal of CO2 from Simulated Flue Gas of Power Plants by Membrane-Based Gas Absorption Processes

Comparison of Capture Efficiencies of Carbon Dioxide by Fine Spray of Aqueous Ammonia and MEA Solution

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method