Abstract:Although ammonia-based CO2 capture has attracted global research attention, several inherent issues with this technology remain to-be resolved. To address these problems, a new design for carbon capture using ammonia is proposed on the basis of anti-solvent crystallization, also known as precipitation crystallization. The crystallization of a low carbonized absorbent was found to-be, enhanced in the crystallizer using an-anti-solvent process, which can maintain a high absorption rate and simultaneously prevent crystallization from occurring in the absorption tower. Energy consumption for sorbent regeneration is, reduced by regenerating the crystal product rather than the rich-solution. Energy-cascade utilization-is an effective way to improve the use of energy. In this work, steam was used to drive a heat pump that extracts energy from discharged flue gas from a wet flue gas desulfurization system in. a power plant to enablethe recovery of low-temperature residual energy; this energy can be used in the crystal regeneration process, thereby further reducing the energy required for regeneration. Aspen Plus (version 8.4) software was adopted:to simulate the flue gas condensation, heat-pump circulation, and steam drive'-subsystems. The simulation results showed that 10 heat pumps (6.04 MW) can meet the regeneration energy requirement of the CO, capture process in a 300 MW coal-fired unit and recycle 40.6 MW of low-temperature heat. The extraction steam requirement is low, which reduces the impact on power-generation.

Process simulations of large-scale CO2 capture in coal-fired power plants using aqueous ammonia solution

Process simulations of NH3 abatement system for large-scale CO2 capture using aqueous ammonia solution

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Experimental Study and Numerical Simulation on CO2 Capture from Flue Gas Using Amine-Based Absorbent in Coal-Fired Power Plant

Simulation of CO2 capture using ammonia scrubbing: A comparison with MEA scrubbing

Performance Simulations of Mea/Nh3 Based Large-Scale Co2 Capture in Packed Columns under Different Flue Gas Parameters

Experimental Studies And Rate-Based Process Simulations Of Co2 Absorption With Aqueous Ammonia Solutions

Pilot-Scale Experimental Study on the CO2 Capture Process with Existing of SO2: Degradation, Reaction Rate, and Mass Transfer

Rate-based modelling of CO2 regeneration in ammonia based CO2 capture process

Simulation Optimization of A New Ammonia-Based Carbon Capture Process Coupled with Low-Temperature Waste Heat Utilization

Simulation and Analysis of Carbon Dioxide Capture Process with Split Flow Modification Using MDEA/PZ Blend Solution in a Coal-fired Power Plant

Dynamic modelling and simulation of a post-combustion CO2 capture process for coal-fired power plants

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

A novel process for capturing carbon dioxide using aqueous ammonia

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

Modeling Analysis of Energy Requirement in Aqueous Ammonia Based CO2 Capture Process

Experimental Research Of Co2 Removal By Ammonia Solutions From Flue Gas Of Coal-Fired Power Plant

Process modeling of an advanced NH₃ abatement and recycling technology in the ammonia-based CO₂ capture process

Modelling and Process Analysis of Post-Combustion Carbon Capture with the Blend of 2-Amino-2-methyl-1-propanol and Piperazine

Simulation of a CO_2 Capture System Using Amine Solutions for Selection of Absorbents

Dynamic Simulation of Post-Combustion Capture System