Abstract:CO 2 is the primary greenhouse gas causing global warming which has aroused increasing alarm all over the world. Fossil fuels used for power generation account for a large amount of anthropogenic CO 2 emission which may greatly affect the global climate. According to IPCC 2013 report, carbon dioxide concentrations primarily from fossil fuel emissions have increased by nearly 40% since pre-industrial times, and it is likely to be responsible for the average increase in the global temperature observed during the past 150 years. It is a great challenge to capture CO 2 from power plant. Interest has arisen in capturing and sequestering CO 2 generated in fossil fuel combustion. Chemical looping combustion, introduced in 1983, is a promising technology to capture CO 2 release into the atmosphere at a low cost. It provides an inherent feature of isolating CO 2 in the flue gas, which avoids the CO 2 diluted by nitrogen. This is accomplished by using two reactors, where subsequent oxidation and reduction reactions take place respectively. The direct contact between air and fuel is circumvented, thus, the flue gas leaving the fuel reactor only includes CO 2 and H 2 O. After the condensation of H 2 O, almost pure CO 2 is obtained with a small energy loss. Numbers of CFD studies, which offer the capacity of studying a system under conditions over its limits, were carried out on chemical looping combustion. It can be applied to various systems to obtain a beforehand idea of the process design, development and scale-up. The reaction of coal in CLC is complex and can be divided into pyrolysis, gasification and combustion et al. Until now, most studies focus on the fuel reactor or air reactor, individually. We can find few papers present the simulation of the full loop structure with reaction for chemical looping system and the integrated effect on complete process is missing. Thus, the purpose of this work attempts to fill the gap by developing a computational model for coal-fired chemical looping combustion system with full loop structure. The heterogeneous and homogeneous reactions are coupled with the multiphase computational fluid dynamics model. For the fuel reactor, the two-equation model and shrinking-core model are adopted for the coal pyrolysis and char gasification, respectively. The circulating behavior of oxygen carrier is first investigated under different operating conditions. The products from fuel reactor are analyzed and compared with experimental data to validate the accuracy of model. Conversion efficiency of fuel, carbon capture efficiency and oxide oxygen fraction are studied to evaluate the system. Then heat and mass transfer characteristic, gas-solid flow patterns, specie distributions and other important parameters are investigated for better understanding the operation of CLC system.

Dynamic modelling and simulation of a post-combustion CO2 capture process for coal-fired power plants

Dynamic Simulation of Post-Combustion Capture System

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Dynamic Operation and Simulation of Post-Combustion CO2 Capture

Dynamic modelling, identification and preliminary control analysis of an amine-based post-combustion CO2 capture pilot plant

Investigation of the Dynamic Behavior and Control Strategies for a CO2 Capture System Using Amine Solution

Energy-efficient Process Intensification for Post-Combustion CO2 Capture: A Modeling Approach

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

Process and Integration Optimization of Post-Combustion CO2 Capture System in a Coal Power Plant

Experimental Study of the Dynamic Behavior of the Stripping Column for Post-combustion CO2 Capture with Monoethanolamine

Energy-efficient Solvent Properties for the Post-combustion Carbon Dioxide Capture

Simulation and Optimization of Carbon Dioxide Capture Using Water-Lean Solvent from Industrial Flue Gas

Modelling and Process Analysis of Post-Combustion Carbon Capture with the Blend of 2-Amino-2-methyl-1-propanol and Piperazine

Study on heat integration of supercritical coal-fired power plant with post-combustion CO2 capture process through process simulation

Upgrading the Integration of Supercritical Coal-Fired Power Plant with Post-Combustion CO<SUB Align="right">2 Capture Process Through Process Simulation

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

CFD investigation of post-combustion CO 2 capture using an industrial spray tower: Regulation effects of spray schemes

Assessment of Hybrid Solvent—Membrane Configurations for Post-Combustion CO2 Capture for Super-Critical Power Plants

Dynamic modeling and control for pulverized-coal-fired oxy-combustion boiler island

Numerical Modeling of Flow and Reaction Characteristic in Chemical Looping Combustion System

Dynamic Modelling And Simulation Of Igcc Process With Texaco Gasifier Using Different Coal