Abstract:Monoethanolamine (MEA) based CO2 capture in coal-fired power plants would consume a huge amount of the steam bleed from the steam turbines for the solvent regeneration. The unmatched steam bleed parameters for the solvent regeneration, as well as the huge amount of the process waste heat within the CO2 capture process, inevitably bringing about a significant efficiency penalty. In this study, a novel de-carbonization supercritical coal-fired power plant, which encompasses a supplementary steam turbine (SST), process heat recovery and a modified boiler heating exchangers configuration was proposed. In the proposed system, the steam bleeds for the reboiler and part of the regenerative heaters are coming from the SST, which is located in the upstream of the reheater (steam side), instead of the high and intermediate-pressure turbines (IPT), making the parameters of the steam bleed more matched with the solvent regeneration and feed water heating. In addition, part of the process heat within the CO2 capture/compression unit was efficiently recovered and beneficially used to heat the ambient air before its entering the air pre-heater. The saved flue gas can then be used to heat the feed/condensed water in the low-temperature economizer (LTE), saving part of the steam bleed from the turbines. The configuration of the superheaters/reheaters, as well as the air preheaters were also modified. The mass and energy balance as well as the system thermodynamic performance were determined by the developed models and process simulation. The economic performance of the proposed system was assessed by the cost of electricity (COE) and the cost of CO2 avoided (COA). Finally, the off-design performance of the proposed system was determined. Results showed that the energy efficiency penalty of the proposed system could decrease by 3.86%-points as compared to the reference system. The COE and COA of the proposed system without considering the CO2 transportation and storage cost were $86.11/MWh and $36.92/ton CO2, respectively, both less than those of the reference plant. The off-design operation analysis indicated that the proposed plant also featured a thermodynamics superiority in a wide range of power load variation.

Assessment of Hybrid Solvent—Membrane Configurations for Post-Combustion CO2 Capture for Super-Critical Power Plants

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Membrane CO2 Separation System Improvement for Coal-Fired Power Plant Integration

Experimental Study on Hybrid MS‐CA System for Post‐combustion CO2 Capture

An integrated de-carbonization supercritical coal-fired power plant incorporating a supplementary steam turbine, process heat recovery and a modified boiler structure

Understanding the performance of membrane for direct air capture of CO2

Hybrid Advanced Control Strategy for Post-Combustion Carbon Capture Plant by Integrating PI and Model-Based Approaches

Optimised integration of post-combustion CO2 capture process in greenfield power plants

Comparative Analysis of the Efficiency Penalty in Power Plants of Different Amine-Based Solvents for CO2 Capture

Post-combustion carbon capture process modeling, simulation, and assessment of synergistic effect of solvents

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

Industrial test of post combustion CO2 capture by reactive absorption with two new solvents in natural gas power plant

Techno-Economic Evaluation on Solar-Assisted Post-Combustion CO2 Capture in Hollow Fiber Membrane Contactors

CO2 Capture by Using a Membrane-absorption Hybrid Process in the Nature Gas Combined Cycle Power Plants

Integration Study of a Hybrid Solvent MEA-Methanol for Post Combustion Carbon Dioxide Capture in Packed Bed Absorption and Regeneration Columns

Post-combustion slipstream CO2-capture test facility at Jiangyou Power Plant, Sichuan, China: performance of a membrane separation module under dynamic power-plant operations

Insight and Comparison of Energy-efficient Membrane Processes for CO2 Capture from Flue Gases in Power Plant and Energy-intensive Industry

Multi-stage Solvent Circulation Absorption Enhancement: System Optimization for Energy-Saving CO2 Capture

Novel approach to CO 2 capture: Improving the hybridization between membranes and calcium-looping

Process and Integration Optimization of Post-Combustion CO2 Capture System in a Coal Power Plant

Experimental Study of the Absorption and Regeneration Performance of Several Candidate Solvents for Post-Combustion CO2 Capture