Abstract:Monoethanolamine (MEA) based CO2 capture in coal-fired power plants would consume a huge amount of the steam bleed from the steam turbines for the solvent regeneration. The unmatched steam bleed parameters for the solvent regeneration, as well as the huge amount of the process waste heat within the CO2 capture process, inevitably bringing about a significant efficiency penalty. In this study, a novel de-carbonization supercritical coal-fired power plant, which encompasses a supplementary steam turbine (SST), process heat recovery and a modified boiler heating exchangers configuration was proposed. In the proposed system, the steam bleeds for the reboiler and part of the regenerative heaters are coming from the SST, which is located in the upstream of the reheater (steam side), instead of the high and intermediate-pressure turbines (IPT), making the parameters of the steam bleed more matched with the solvent regeneration and feed water heating. In addition, part of the process heat within the CO2 capture/compression unit was efficiently recovered and beneficially used to heat the ambient air before its entering the air pre-heater. The saved flue gas can then be used to heat the feed/condensed water in the low-temperature economizer (LTE), saving part of the steam bleed from the turbines. The configuration of the superheaters/reheaters, as well as the air preheaters were also modified. The mass and energy balance as well as the system thermodynamic performance were determined by the developed models and process simulation. The economic performance of the proposed system was assessed by the cost of electricity (COE) and the cost of CO2 avoided (COA). Finally, the off-design performance of the proposed system was determined. Results showed that the energy efficiency penalty of the proposed system could decrease by 3.86%-points as compared to the reference system. The COE and COA of the proposed system without considering the CO2 transportation and storage cost were $86.11/MWh and $36.92/ton CO2, respectively, both less than those of the reference plant. The off-design operation analysis indicated that the proposed plant also featured a thermodynamics superiority in a wide range of power load variation.

Optimised integration of post-combustion CO2 capture process in greenfield power plants

Study on heat integration of supercritical coal-fired power plant with post-combustion CO2 capture process through process simulation

Process and Integration Optimization of Post-Combustion CO2 Capture System in a Coal Power Plant

Upgrading the Integration of Supercritical Coal-Fired Power Plant with Post-Combustion CO<SUB Align="right">2 Capture Process Through Process Simulation

Assessment of Hybrid Solvent—Membrane Configurations for Post-Combustion CO2 Capture for Super-Critical Power Plants

Membrane CO2 Separation System Improvement for Coal-Fired Power Plant Integration

Energy-efficient Process Intensification for Post-Combustion CO2 Capture: A Modeling Approach

An integrated de-carbonization supercritical coal-fired power plant incorporating a supplementary steam turbine, process heat recovery and a modified boiler structure

Dynamic Operation and Simulation of Post-Combustion CO2 Capture

Optimization study of CO 2 capture unit for subcritical coal-fired power generation unit based on Ebsilon and Aspen plus

Dynamic modelling, identification and preliminary control analysis of an amine-based post-combustion CO2 capture pilot plant

Optimizing post-combustion carbon capture: A comprehensive 3E analyses of energy, exergy, and exergoeconomic aspects with solar integration

Energy, Exergy, Economic and Environmental (4E) Analysis of an Integrated Process Combining CO2 Capture and Storage, an Organic Rankine Cycle and an Absorption Refrigeration Cycle

Optimization of Post Combustion CO2 Capture from a Combined-Cycle Gas Turbine Power Plant via Taguchi Design of Experiment

Dynamic modelling and simulation of a post-combustion CO2 capture process for coal-fired power plants

Carbon Capture Performance Assessment Applied to Combined Cycle Gas Turbine Under Part-Load Operation

Hybrid Advanced Control Strategy for Post-Combustion Carbon Capture Plant by Integrating PI and Model-Based Approaches

An update of the benchmark post-combustion CO2-capture technology

Enabling post combustion capture optimization–The pilot plant project at Niederaussem

Modelling and Process Analysis of Post-Combustion Carbon Capture with the Blend of 2-Amino-2-methyl-1-propanol and Piperazine

CCUS-assisted electricity-chemical polygeneration system for decarburizing coal-fired power plant: Process integration and performance assessment