Abstract:Compared to conventional monoethanolamine (MEA), alternative solvents are expected to substantially contribute to reduce the energy demand of post-combustion CO 2 capture from flue gases. This study presents a comprehensive techno-economic analysis of a 27 wt% 2-amino-2-methyl-1-propanol (AMP) + 13 wt% piperazine (PZ) aqueous solution for CO 2 capture, compared to a 30 wt% MEA solution. The study addresses the retrofit of a carbon capture unit to a biomass-fired combined heat and power (CHP) plant, effectively making it a bioenergy with a carbon capture and storage (BECCS) system. The treated flue gas has a flow rate of 23 tons/hour (t/h) with 11.54 vol% CO 2 and a 90% capture rate is aimed for. Aspen Plus V14 was employed for process simulations. Initially, binary interaction parameters for AMP/PZ, AMP/H 2 O, and PZ/H 2 O are regressed using vapor-liquid equilibrium (VLE) data, which were retrieved from literature along with reaction kinetics. Validation of parameters from available experimental literature yields an average absolute relative deviation (AARD) of only 5.9%. Afterwards, a process simulation model is developed and validated against experimental data from a reference pilot plant, using a similar AMP/PZ blend, resulting in 5% AARD. Next, a sensitivity analysis optimizes operating conditions, including solvent rate, absorber/stripper packing heights, and stripper pressure, based on regeneration energy impact. Optimized results, compared to MEA, reveal that AMP/PZ reduces the energy consumption from 3.61 to 2.86 GJ/tCO 2 . The retrofitting of the capture unit onto the selected CHP plant is examined through the development of a dedicated model. Two control strategies are compared to address energy unavailability for supplying the capture unit. The analysis spans 4 months, selected to account for seasonal variations. At nominal capacity, CO 2 emissions, rendered negative by biomass combustion and CO 2 capture, reach a maximum of −3.4 tCO 2 /h compared to 0.36 tCO 2 /h before retrofitting. Depending on the control strategy and CHP plant operating point, the Specific Primary Energy Consumption for CO 2 Avoided (SPECCA) ranges from 4.91 MJ/kgCO 2 to 1.76 MJ/kgCO 2 . Finally, an economic comparison based on systematic methodology reveals a 7.87% reduction in capture cost favoring the AMP/PZ blend. Together, these findings highlight AMP/PZ as a highly favorable alternative solvent.

Enabling post combustion capture optimization–The pilot plant project at Niederaussem

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

Optimised integration of post-combustion CO2 capture process in greenfield power plants

Post-Combustion CO2 Capture Demonstration Using Supported Amine Sorbents: Design and Evaluation of 200 Kwth Pilot

Aqueous Ammonia Based Post Combustion Capture: Results from Pilot Plant Operation, Challenges and Further Opportunities

Dynamic Operation and Simulation of Post-Combustion CO2 Capture

Practical Experience in Post-combustion CO2 Capture Using Reactive Solvents in Large Pilot and Demonstration Plants

Modelling and Process Analysis of Post-Combustion Carbon Capture with the Blend of 2-Amino-2-methyl-1-propanol and Piperazine

Dynamic modelling, identification and preliminary control analysis of an amine-based post-combustion CO2 capture pilot plant

Integrated Capture and Conversion of CO2 to Methane using a Water-lean, Post-Combustion CO2 Capture Solvent.

Optimization of Post Combustion CO2 Capture from a Combined-Cycle Gas Turbine Power Plant via Taguchi Design of Experiment

Full-scale FEED Study for Retrofitting the Prairie State Generating Station with an 816 MWe Capture Plant using Mitsubishi Heavy Industries Engineering Post-Combustion CO2 Capture Technology

Industrial test of post combustion CO2 capture by reactive absorption with two new solvents in natural gas power plant

Simulation of a Pilot Scale Power-to-Liquid Plant Producing Synthetic Fuel and Wax by Combining Fischer–Tropsch Synthesis and SOEC

Study on process intensification of pre combustion CO capture

Pilot-Scale Experimental Study on the CO2 Capture Process with Existing of SO2: Degradation, Reaction Rate, and Mass Transfer

Performance and economic viability assessment of a novel CO 2 adsorbent for manufacturing and integration with coal power plants

Assessment of Hybrid Solvent—Membrane Configurations for Post-Combustion CO2 Capture for Super-Critical Power Plants

Techno-economic analysis and optimisation of Piperazine-based Post-combustion carbon capture and CO 2 compression process for large-scale biomass-fired power plants through simulation

Techno-economic analysis of AMP/PZ solvent for CO2 capture in a biomass CHP plant: towards net negative emissions

Performance study on mixed solvent for post‐combustion carbon capture using rotating packed bed technology