Abstract:Coal-fired power plants are one of the major sources of CO2 emission, and the novel application of directly co-firing the carbon-free fuel ammonia into the coal-fired power plants is emerging as a promising method of CO2 emission reduction. In this study, simulations of the boiler system of a 600 MWe coal-fired power plant unit were performed in both coal-fired condition and ammonia-coal co-firing conditions, and the impacts of ammonia co-firing on the emission and thermal properties of flue gas, exergy loss, and exergy efficiency were analyzed. Two co-firing scenarios (identical adiabatic flame temperature scenario and identical excess air coefficient scenario) were compared, both assuming that the total heating value of the fuel into the furnace kept unchanged with different ammonia co-firing ratios (5%, 10%, 15%, 20% on heating value basis). The results showed that CO2 emission was effectively reduced by 24.08 t/h for every 5% increase in the ammonia co-firing ratio. The amount of total flue gas was also reduced while both the content and the emission rate of H2O were increased with ammonia co-firing. Consequently, the specific heat capacity of flue gas increased and further changed its temperature distribution profile. Compared with the coal-fired base case, the exergy loss in the furnace under the ammonia co-firing conditions increased continuously as the ammonia co-firing ratio increased, suggesting that the irreversible loss of the ammonia combustion process was greater than that of coal. By contrast, the exergy loss of heat exchangers and fans decreased in ammonia co-firing conditions. Finally, the exergy efficiency of the boiler system was only slightly reduced (53.82% vs. 53.27%–53.22%) in ammonia co-firing conditions, showing that co-firing ammonia in coal-fired power plant would not significantly deteriorate the thermal economy.

Experimental Research Of Co2 Removal By Ammonia Solutions From Flue Gas Of Coal-Fired Power Plant

Research progress of CO2 capture by using ammonia from flue gas of power plant

Kinetics and mass transfer of carbon dioxide absorption into aqueous ammonia

Simulation of CO2 capture using ammonia scrubbing: A comparison with MEA scrubbing

Carbon Dioxide Recovery From Flue Gases By Ammonia Scrubbing

Absorption of carbon dioxide in aqueous ammonia

Experimental Study and Numerical Simulation on CO2 Capture from Flue Gas Using Amine-Based Absorbent in Coal-Fired Power Plant

Semi-batch experimental study on CO2 absorption characteristic of aqueous ammonia

Simultaneous Absorption of SO2 and CO2 from Flue Gas Using Aqueous Ammonia

Recovery of carbon dioxide by ammonia scrubbing in power plants

Recent Progress of Amine Modified Sorbents for Capturing CO2 from Flue Gas

Investigation on the ammonia emission characteristics in coal-fired power plants of China

The present situation, challenges, and prospects of the application of ammonia–coal co-firing technology in power plant boilers

On Macro Parameters of CO2 Capture by Ammonia Method

Mitigating CO2 emission in pulverized coal-fired power plant via co-firing ammonia: A simulation study of flue gas streams and exergy efficiency

Impact of SO2 on CO2 capture in coal-fired flue gas using aqueous ammonia

Research and Application Analysis on the Pollution Control of Tail Gas Emissions from Co2 Capture Absorber

Study on removal of CO2 greenhouse gas by mixture of ammonia and soil

The Advances of Post-combustion CO2 Capture with Chemical Solvents: Review and Guidelines

Experimental Studies on Removal Capacity of Carbon Dioxide by a Packed Reactor and a Spray Column Using Aqueous Ammonia

Experimental Comparison of Flue Gas CO_2 Separation with Membrane Absorption and Chemical Absorption