Abstract:Two typical CO2 chemical absorption processes using MEA and aqueous ammonia (AA) solutions to act as absorbents and one novel process using hollow fiber membrane contactors (HFMCs) to act as absorber and MEA as absorbent were analyzed in this study to find out what CO2 capture process may be more suitable for China. An ultra supercritical PC power plant with 840-MWe-gross-output was selected as the reference case without CO2 capture. Economic results show that when membrane price is set at RMB 50/m(2) and lifetime is 5 years, CAPEX of MEA, HFMC and AA cases are increased by about 90.12%, 85.4% and 68%, respectively, compared to reference case. And the corresponding cost of avoided is RMB 305.1/tCO(2), RMB 266.45/tCO(2) and RMB 206.02/tCO(2), respectively. The seemingly positive results imply that AA-based chemical absorption process should be the best for China nowadays. In addition, prospect of HFMC process in the future was also considered based on the increasing anxiety of NH3 slip for AA process. If membrane price can be reduced to less than RMB 20/m(2) and new solvents with similar to 3 GJ/tCO(2) total regeneration heat requirement can be adopted in the future, HFMC may replace the AA-based method to capture CO2. Additionally, economic results also show that the development of new solvents only considering the reduction of heat of CO2 absorption may be not sufficient in terms of the reduction of CO2 avoided cost. That is because CO2 avoided cost can only be reduced by about 8% even the heat of CO2 absorption can be reduced by about 60%. Finally, effects of coal price, improvements of reference case and CO2 capture system on the cost of CO2 avoided were also investigated. (C) 2010 Published by Elsevier Ltd.

Research and Application Analysis on the Pollution Control of Tail Gas Emissions from Co2 Capture Absorber

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Emission and Control of Flue Gas Pollutants in CO2 Chemical Absorption System – A Review

Solvent emissions control in large scale chemical absorption CO2 capture plant

Research and Design Experience of a 150 Kt/A Co2 Capture and Purification Project in the Shaanxi Guohua Jinjie Power Plant

Study on the Control of Condensable Particulate Matter by Spraying Activated Carbon Combined with Electrostatic Precipitator

Research and design experience of a 150 kt/a CO 2 capture and purification project in the Shaanxi Guohua Jinjie power plant

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

The experience in the research and design of a 2 million tons/year flue gas CO2 capture project for coal-fired power plants

Pilot-Scale Experimental Study of a New High-Loading Absorbent for Capturing CO2 from Flue Gas

Distribution and Emission Characteristics of Filterable and Condensable Particulate Matter in the Flue Gas Emitted from an Ultra-Low Emission Coal-Fired Power Plant

Experimental Study and Numerical Simulation on CO2 Capture from Flue Gas Using Amine-Based Absorbent in Coal-Fired Power Plant

Research on Modern CO2 Absorption Process

Reducing Aerosol Emissions by Decoupled Parameter Management During the CO2 Capture Process in a Multi-stage Circulation Absorber.

Economic Analysis of CO2 Separation from Coal-Fired Flue Gas by Chemical Absorption and Membrane Absorption Technologies in China

Reducing aerosol and ammonia emission in post-combustion CO 2 capture: Additives as key solutions

Experimental Research Of Co2 Removal By Ammonia Solutions From Flue Gas Of Coal-Fired Power Plant

Development and property study of two-phase absorbent for carbon capture in coal-fired flue gas

Development Of Multi-Pollutants Control Technology For Flue Gas From Power Plants In China

High amine emissions formation and aerosol particle size distribution in post-combustion CO2 capture process

Pilot-Scale Experimental Study on the CO2 Capture Process with Existing of SO2: Degradation, Reaction Rate, and Mass Transfer