Abstract:While there is a desire for the use of sustainable/renewable energy to reduce net carbon dioxide emissions, fossil fuels will continue to serve as the dominant energy source in the near future, because of their availability and high energy density. To reduce carbon dioxide emissions from hydrocarbon energy sources, many carbon capture methods are being explored; post-combustion carbon dioxide chemical absorption technology is the most feasible near-term solution. Since MEA absorption or chilled ammonia based carbon dioxide capture processes are energy-intensive and expensive to construct and operate, model-based design and operation of the carbon capture process is useful to reduce capital cost and energy consumption. In this work a rate-based steady-state model of an integrated MEA-based carbon dioxide capture system, consisting of an absorber and stripper, is developed using the widely-accepted commercial platform-Aspen Plus. The rate-based model has better predictive capability than the equilibrium-based model, and agrees well with experimental data from the pilot plant at the University of Texas at Austin (Zhang et al, 2009). Based on this steady-state model, comprehensive flowsheet parametric studies have been done to investigate the integrated system characteristics. The steady-state model is converted into a dynamic model in Aspen Dynamics; because of software limitations, the equilibrium reactions in Aspen Dynamics must be converted into kinetic expressions with the equivalent equilibrium behavior. The resulting dynamic model is used to analyze the dynamic characteristics of the carbon dioxide capture process. Model-based control and optimization is shown to be a valuable tool to improve overall energy efficiency and therefore reduce the operational cost of clean coal-fired power generation system with carbon capture.

Process modeling of an advanced NH₃ abatement and recycling technology in the ammonia-based CO₂ capture process

Simulation Optimization of A New Ammonia-Based Carbon Capture Process Coupled with Low-Temperature Waste Heat Utilization

Rate-based modelling of combined SO 2 removal and NH 3 recycling integrated with an aqueous NH 3 -based CO 2 capture process

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

Rate based modeling of absorption and regeneration for CO2 capture by aqueous ammonia solution

Modeling Analysis of Energy Requirement in Aqueous Ammonia Based CO2 Capture Process

Rate-Based Modeling of CO2 Absorption in Aqueous NH3 in a Packed Column

Process simulations of NH3 abatement system for large-scale CO2 capture using aqueous ammonia solution

Modeling and Economic Analysis on Combined Capture of CO2 and SO2 in Flue Gas Using Aqueous Ammonia

Rate-Based Modeling Of Regeneration Process For Co2 Capture By Aqueous Ammonia Solution In A Pilot Plant At Munmorah Power Station

Systematic study of aqueous monoethanolamine‐based CO2 capture process: model development and process improvement

A novel process for capturing carbon dioxide using aqueous ammonia

Meso-scale CFD Modelling of CO2 Capture by Aqueous Ammonia Part I: Modeling

Rate-based modelling of CO2 regeneration in ammonia based CO2 capture process

Dynamic modeling and analysis of a post-combustion carbon dioxide capture system

Comparison of Thermodynamic Models for Carbon Capture with Aqueous Ammonia

A Comprehensive Model for Regeneration Process of CO 2 Capture Using Aqueous Ammonia Solution

Experimental Studies And Rate-Based Process Simulations Of Co2 Absorption With Aqueous Ammonia Solutions

Energy-efficient Process Intensification for Post-Combustion CO2 Capture: A Modeling Approach

4E Evaluation and Multi-Objective Optimization of Low Concentration Flue Gas CO2 Capture and Multi-Product Conversion Process