Abstract:In this study, the process of carbon dioxide (CO2) capture directly from ambient air in a conventional monoethanolamine (MEA) absorption process was simulated and optimized using a rate-based model in Aspen Plus. The process aimed to capture a specific amount (148.25 Nm3/h) of CO2 from the air, which was determined by a potential application aiming to produce synthetic methane from the output of a 2.7 MW electrolyser (593 Nm3/h H2). We investigated the technical performance of the process by conducting a sensitivity analysis around different parameters such as air humidity, capture rate defined as a ratio of moles of CO2 captured during the process to the total mole of CO2 in the feed stream, CO2 loading of lean and rich absorption liquids and reboiler temperature, and evaluated the energy consumption and overall cost in this system. In order to meet the design requirement for standard packed columns, the rich absorption liquid was circulated to the top of the absorber. A capture rate of 50% was selected in this process as a baseline. At higher capture rates, the required energy per ton of captured CO2 increases due to a higher steam stripping rate, required in the desorber, and at lower capture rates, the size of equipment, in particular, absorber and blowers increases due to the need for processing a significantly larger volume of air at the given CO2 production volume. At the base case scenario, a reboiler duty of 10.7 GJ/tCO2 and an electrical energy requirement of 1.4 MWh/tCO2 were obtained. The absorber diameter and height obtained were 10.4 and 4.4 m, respectively. The desorber is found to be relatively small at 0.54 m in diameter and 3.0 m in height. A wash water section installed at top of the absorber decreased the MEA loss to 0.28 kg/ton CO2. However, this increased capital cost by around 60% resulting in CO2 capture costs of $1,691 per ton CO2 for the MEA base scenario. Based on the techno-economic analysis, assuming a non-volatile absorbent rather than MEA thereby avoiding a wash water section, and using an absorption column built from cheaper materials, the estimated cost per ton of CO2 produced was reduced to $676/tCO2. The overall cost range was between $273 and $1,227 per ton of CO2 depending on different economic parameters such as electricity ($20–$200/MWh) and heat price ($2–$20/GJ), plant life (15–25 years) and capital expenditure (±30%). In order to reduce the cost further, the use of innovative cheap gas-liquid contactors that operate at lower liquid to gas ratios is crucial.

Experimental And Rate-Based Modeling Study Of Co2 Capture By Aqueous Monoethanolamine

Effect of Operating Parameters on CO 2 Capture from Biogas with Choline Chloride—monoethanolamine Deep Eutectic Solvent and Its Aqueous Solution

MEA-based CO2 capture: a study focuses on MEA concentrations and process parameters

Systematic study of aqueous monoethanolamine‐based CO2 capture process: model development and process improvement

Energy minimization in monoethanolamine‐based CO2 capture using capacitive deionization

A Coupling Calculation Method of Desorption Energy Distribution Applied to CO2 Capture by Chemical Absorption

Experimental Study of Energy Requirement of CO2 Desorption from Rich Solvent

Techno-Economic Assessment for CO2 Capture From Air Using a Conventional Liquid-Based Absorption Process

Simulation of a CO_2 Capture System Using Amine Solutions for Selection of Absorbents

Evaluation of hybrid amines and alcohol solvent with ion-exchange resin catalysts for energy-efficient CO 2 capture

Modeling Analysis of Energy Requirement in Aqueous Ammonia Based CO2 Capture Process

A multiobjective experimental based optimization to the CO2 capture process using hybrid solvents of MEA-MeOH and MEA-water

Experimental Study Of Co2 Solubility In High Concentration Mea Solution For Intensified Solvent-Based Carbon Capture

Process Simulation and Energy Consumption for CO<SUB Align="right">2 Capture with Different Flowsheets

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

Absorption solubility calculation and process simulation for CO; capture

Mathematical Modelling and Experimental Investigation of CO2 Absorber Recovery Using an Electro-Acidification Method

Absorption Solubility Calculation and Process Simulation for CO2 Capture

Experimental Investigation of Amine Regeneration for Carbon Capture through CO2 Mineralization

A Novel Diamine Non-Aqueous Absorbent Based on N-methyl diethanolamine Regulation for Energy-efficient CO2 Capture

Experimental research on chemical desorption based on CO2-rich absorption solutions