Abstract:Using a new kind of absorbent which is the mixture of aqueous ammonia and ethanol, a process of carbon capture by ammonia of low concentration with reinforced crystallization and lower energy consumption is presented. By the application of antisolvent crystallization to reinforce crystallization process, low energy consumption of regeneration could be achieved easily due to saving the energy to heat the water of carbonized ammonia in the desorption process. TGA is adopted to study the regeneration process of crystal product, and heating method pyrolysis and constant temperature pyrolysis are used respectively. What' s more, if the waste heat from the power plant can be used as heat source of the regeneration process, the more energy can be saved for the technology. With the regeneration temperature between 40 ℃and 80 ℃, the active energy can be as low as 48.38 kJ/mol. The regeneration process is studied at the constant temperature of 60℃, 80℃ and 100℃. And if the rate of rising temperature is 5 K/min, the crystal product will be totally decomposed when the temperature reaches 80℃,not only can achieve low energy consumption but also have fast regeneration rate which have the advantage over the process of rich carbonated ammonia. For the mixed absorbent, the different proportion of the dissolved agent has little effect on the regeneration process, and the composition of the mixture is determined only by the absorption rate. The better regeneration rate can be obtained by the constant temperature of 80 ℃. After the calculation of 16 classical models, the model function was selected for the study of crystal products.

Modelling analysis of solid precipitation in an ammonia-based CO 2 capture process

MODELLING AND SIMULATION OF CARBONATION PROCESS OF AMMONIACAL BRINE Ⅱ THE REACTOR/CRYSTALLIZER MODEL OF CARBONATION COLUMNS

Rate-based modelling of CO2 regeneration in ammonia based CO2 capture process

Modeling Analysis of Energy Requirement in Aqueous Ammonia Based CO2 Capture Process

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

A Comprehensive Model for Regeneration Process of CO 2 Capture Using Aqueous Ammonia Solution

Rate-Based Modeling Of Regeneration Process For Co2 Capture By Aqueous Ammonia Solution In A Pilot Plant At Munmorah Power Station

Rate-Based Modelling and Validation of an Absorber and Stripper in an Amine-Based Post-Combustion CO2 Capture Process

Development of a novel process for aqueous ammonia based CO 2 capture

Rate based modeling of absorption and regeneration for CO2 capture by aqueous ammonia solution

Regenerative process analysis of the new carbon capture technique based on mixed absorbent

Effect of carbonized ammonia constituent on the crystallization process

Comparison of Thermodynamic Models for Carbon Capture with Aqueous Ammonia

Process modeling of an advanced NH₃ abatement and recycling technology in the ammonia-based CO₂ capture process

On Reaction Models of Regeneration Process for NH 3 -Based CO 2 Capture

Process simulations of NH3 abatement system for large-scale CO2 capture using aqueous ammonia solution

Rate-based modelling of combined SO 2 removal and NH 3 recycling integrated with an aqueous NH 3 -based CO 2 capture process

Two kinds of new carbon capture technology by ammonia based on reinforced crystallization

Analysis on Regeneration Energy of NH3-based CO2 Capture with Equilibrium-based Simulation Method

On Reaction Models of Regeneration Process for NH3-Based CO2 Capture

Bi-disperse Adsorption Model of the Performance of Amine Adsorbents for Direct Air Capture