Abstract:Aiming to solve the problem of high ammonia loss during ammonia‐based CO 2 chemical absorption process, an ammonia wash system was recommended to be added after the absorber column. Hence, we need to deal with a lot of wash water. Recently, we proposed a vacuum membrane distillation (VMD) system to regenerate ammonia from ammonia wash water. The stripping gaseous ammonia can be used for producing a high‐concentration ammonia solution for solvent make‐up in the CO 2 capture system, and the wash water after distillation can be reused. In this work, we investigated 0.3 M ammonia solutions on different operation factors such as feed flow rate, feed temperature, pressure in the permeate side, and CO 2 loading. The experimental results show that both temperature and pressure in the permeate side have significant influences on the ammonia stripping process. Increasing feed temperature and reducing pressure in the permeate side will not only improve ammonia removal efficiency, but also enhance total transmembrane flux and overall mass transfer coefficient. The increase of feed flow rate can improve the total transmembrane flux, but will lower the ammonia removal efficiency. The increase of CO 2 loading in the feed ammonia solution will decrease the ammonia removal rate. Furthermore, we investigated a continuous circulation experiment and found that the ammonia removal efficiency largely depended on the removal time. The removal efficiency can be up to 95.6% with a 120 min continuous circulation time. We think this VMD system has the potential to recover ammonia and solve the solvent loss problem. © 2015 Society of Chemical Industry and John Wiley & Sons, Ltd

Development of a novel process for aqueous ammonia based CO 2 capture

Efficient CO<sub>2</sub> capture by a novel deep eutectic solvent through facile, one-pot synthesis with low energy consumption and feasible regeneration

A novel process for capturing carbon dioxide using aqueous ammonia

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Experimental Study on Carbon Dioxide Absorption by Aqueous Ammonia with Nickel and Chromium Ions in Bubbling Tower at Low Temperatures

Carbon capture by ammonia with reinforced crystallization

A Novel Ammonia-Based CO 2 Capture Process Hybrid Ammonia Absorption Refrigeration

A new technique of carbon capture by ammonia with the reinforced crystallization at low carbonized ratio and initial experimental research

Two kinds of new carbon capture technology by ammonia based on reinforced crystallization

New CO2 Capture Process with Gas–Liquid–Solid Three-Phase Circulating Fluidized Bed

Simulation Optimization of A New Ammonia-Based Carbon Capture Process Coupled with Low-Temperature Waste Heat Utilization

Modeling Analysis of Energy Requirement in Aqueous Ammonia Based CO2 Capture Process

A Novel Process for NH3-based CO2 Capture by Integrating Flow-by Capacitive Ion Separation

A Novel Method to Recover Ammonia Loss in Ammonia‐based CO 2 Capture System: Ammonia Regeneration by Vacuum Membrane Distillation

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Process simulations of NH3 abatement system for large-scale CO2 capture using aqueous ammonia solution

Study on Regenerative Process of the New Carbon Capture Technique Based on Antisolvent Crystallization to Strengthen Crystallization

Process modeling of an advanced NH₃ abatement and recycling technology in the ammonia-based CO₂ capture process

Mitigating NH3 Vaporization from an Aqueous Ammonia Process for CO2 Capture

Reducing aerosol and ammonia emission in post-combustion CO 2 capture: Additives as key solutions

Current status and challenges of the ammonia escape inhibition technologies in ammonia-based CO2 capture process