Abstract:Co‐current flow is chosen to represent the collective performance of all flow patterns; A trade‐off between the purity of CO2 and the recovery factor is observed; Despite the reduction of purity, a higher amount of CO2 can be recovered with a larger membrane area; A sharp decline in power requirement is observed with increasing selectivity from 2 to 20. Direct air capture (DAC) of CO2 is becoming increasingly important for reducing greenhouse gas concentrations in the atmosphere. However, the cost and energy requirements associated with DAC make it less economically feasible than carbon capture from flue gases. While various methods like solid sorbents and gas–liquid absorption have been explored for DAC, membrane processes have only recently been investigated. The objective of this study is to examine the separation performance of a membrane unit for capturing CO2 from ambient air. The performance of a membrane depends on several factors, including the composition of the feed gas, pressure ratio, material selectivity, and membrane area. The single‐stage separation process with the co‐current flow and constant permeability flux model is evaluated using a commercial module integrated with a process simulator to separate a binary mixture of carbon dioxide and nitrogen to assess the sensitivity of selectivity on purity and recovery of CO2 in permeate, and power requirement. Additionally, three levels of CO2 reduction from the feed stream to the retentate stream (25%, 50%, and 75%) are studied. A trade‐off between purity and recovery factor is observed, and achieving high purity in permeate requires high concentration in the retentate.

A Novel Process for NH3-based CO2 Capture by Integrating Flow-by Capacitive Ion Separation

Efficient CO<sub>2</sub> capture by a novel deep eutectic solvent through facile, one-pot synthesis with low energy consumption and feasible regeneration

A Comprehensive Model for Regeneration Process of CO 2 Capture Using Aqueous Ammonia Solution

A novel process for capturing carbon dioxide using aqueous ammonia

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Development of a novel process for aqueous ammonia based CO 2 capture

Energy minimization in monoethanolamine‐based CO2 capture using capacitive deionization

Understanding the performance of membrane for direct air capture of CO2

A Process Intensification Approach for CO2 Absorption Using Amino Acid Solutions and a Guanidine Compound

Reaction Sensitivity Analysis of Regeneration Process of CO2 Capture Using Aqueous Ammonia

Carbon capture by ammonia with reinforced crystallization

A Novel Integrated Flow-Electrode Capacitive Deionization and Flow Cathode System for Nitrate Removal and Ammonia Generation from Simulated Groundwater.

Flow-electrode Capacitive Separation of Organic Acid Products and Recovery of Alkali Cations after Acidic CO 2 Electrolysis

Flow-electrode capacitive separation of organic acid products and recovery of alkali cations after acidic CO2 electrolysis

Energy-efficient Process Intensification for Post-Combustion CO2 Capture: A Modeling Approach

Closed‐Loop and Precipitation‐Free CO2 Capture Process Enabled by Electrochemical pH Gradient

An Electrochemical CO 2 Capture Cell Enhanced by Biological Proton‐Carrier Assisted Water Splitting

Process modeling of an advanced NH₃ abatement and recycling technology in the ammonia-based CO₂ capture process

Performance Simulations of Mea/Nh3 Based Large-Scale Co2 Capture in Packed Columns under Different Flue Gas Parameters

Regenerative process analysis of the new carbon capture technique based on mixed absorbent

New CO2 Capture Process with Gas–Liquid–Solid Three-Phase Circulating Fluidized Bed