Abstract:Aqueous ammonia can be used to capture CO2 from flue gas of coal-fired power plant with quick reaction rate, high removal efficiency, and high loading capacity of CO2. It is thought to be a promising technology. However, the CO2 absorption rate, diffusion rate and VLE (Vapor liquid equilibrium) in aqueous ammonia have still been rarely researched. More research is necessary for these characters of ammonia solution as CO2 absorbent. The paper will focus on the fundamental characteristics of CO2 in aqueous ammonia. A series of tests were conducted in a semi-batch reactor that has been developed in this paper. CO2 removal efficiencies at different concentrations of aqueous ammonia have been studied in the similar operation conditions to compare their basic characters in the CO2 absorption process. And a small wetted wall column (WWC) with a contact area of about 41.45 cm(2) was also built for the study of the absorption rate, diffusion, and solubility of carbon dioxide in the aqueous solution. In the paper, reaction rate and overall gas transfer coefficient were studied. The concentration of ammonia ranges from 1, 5, 10 to 15. CO2 and N-2 are used to simulate the flue gas. The concentration of CO2 ranges from 5, 10, 15, to 20%. The reaction temperatures are 20 degrees C and 40 degrees C. It is indicated in this paper that the best concentration of aqueous ammonia should be selected from 5% to 10%. And aqueous ammonia has a high Flux in WWC, which is three times higher than that of MDEA+PZ, under the same condition. It is also found that K-G is appropriate to be used in the mass transfer process of the carbon dioxide absorption by aqueous ammonia. Alls of these experiments established foundation for the further study of CO2 removal by ammonia. (c) 2008 Elsevier Ltd. All rights reserved

New CO2 Capture Process with Gas–Liquid–Solid Three-Phase Circulating Fluidized Bed

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Continuous CO 2 Capture in a Circulating Fluidized Bed Using Supported Amine Sorbents

Continuous CO2 Capture in Dual Fluidized Beds Using Silica Supported Amine

Experiment research on CO2 continuous capture using dual fluidized bed reactors with supported amine

Carbon capture by ammonia with reinforced crystallization

A novel process for capturing carbon dioxide using aqueous ammonia

Carbon dioxide capture by functionalized solid amine sorbents with simulated flue gas conditions.

A Process Intensification Approach for CO2 Absorption Using Amino Acid Solutions and a Guanidine Compound

Ammonia-based post-combustion CO2 and SO2 integrating capture using multi-stage solvent circulation process

Development of a novel process for aqueous ammonia based CO 2 capture

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Two-dimensional full-loop simulation of CO2 capture process in a novel dual fluidized bed system

Mitigating NH3 Vaporization from an Aqueous Ammonia Process for CO2 Capture

Process simulations of NH3 abatement system for large-scale CO2 capture using aqueous ammonia solution

Kinetics and mass transfer of carbon dioxide absorption into aqueous ammonia

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

CFD simulation of a circulating fluidized bed carbon capture system using a solid-supported amine sorbent

Absorption of carbon dioxide in aqueous ammonia

Capture and Separation of CO2 from Flue Gas by Coupling Free and Immobilized Amines.

Research on alkanolamine based physical-chemical solutions as biphasic solvents for CO2 capture