Abstract:China's total carbon emissions are approximately 11 billion tons,with around 40%of CO2 being produced by the coal-fired power plants(CFPP).Therefore,reducing carbon emissions from the CFPP is critical in achieving the Dual-Carbon target.This paper focused on the advancements in the low-carbon/carbon-neutral fuel substitution technologies(such as biomass,sludge,hydrogen/ammonia,etc.)and the CCUS(carbon capture,utilization and storage).The CFPP coupled with biomass includes direct and indirect coupling,but are subject to the supply and price of biomass feedstock.To address these challenges,a comprehensive"planting-harvesting-transportation-storage-pretreatment-combustion"ap-proach was recommended to ensure an effective control throughout the entire chain.Initial pilot test on a 660 MW CFPP revealed a substantial reduction in CO2 emissions by 772500 tons annually.The high-water content of municipal sludge,reaching up to 80%,necessitates drying prior to entering the boiler.Current steam drying and flue gas drying technologies entail substantial investment and operational costs,with the dried sludge still retaining high water content and associated problems such as odor.Consequently,the blending ratio in the CFPP remains below 8%.A sludge carbonization techno-logy based on a biomass heat source can address these challenges,which allows for the direct production of odorless sludge char in sewage plants with a calorific value of about 10.26 MJ/kg.This technology enables an increased blending ratio in the CFPP to 20%-30%,thereby significantly reducing coal consumption and CO2 emissions.The blending of hy-drogen/ammonia necessitates addressing the issues of ammonia escape and NOx emission under high blending ratios.Ex-periments for co-firing of coal and ammonia were conducted on 300 MW and 600 MW CFPP in China to address the chal-lenges of ammonia escape and NOx emissions under high blending ratios.The results showed that combustion control can achieve a higher NH3 burn-up rate with a slight increase in NOx emissions.However,the commercialization of hydrogen/ammonia blending in the CFPP is constrained by the cost of hydrogen and ammonia.The commercialization of pre-combustion decarbonization technology,such as IGCC,faces significant limitations due to high costs.Several foreign demonstration projects were discontinued.The construction costs and equipment reliability are crucial for promoting the commercialization of this technology.Carbon capture technologies in combustion processes include oxygen-enriched combustion and chemical chain combustion.The power generation efficiency of atmospheric oxyfuel combustion is lower by 8%-12%compared to air combustion due to the energy consumption associated with air separation and recycling pro-cesses.Transitioning from atmospheric oxyfuel combustion to pressurized oxyfuel combustion can further increase the net power generation efficiency.Notably,China has constructed the world's largest 4 MW chemical-looping combustion(LCL)demonstration plant.The LCL also has a potential application in the gasification industry.Post-combustion carbon capture predominantly employs the solution absorption technology,while the solid adsorption technology offers a lower regeneration energy consumption.However,some challenges remain in reducing energy consumption and costs to facilit-ate the large-scale commercialization of this technology.

An Advanced, Ammonia-Based Combined NOx/SOx/CO2 Emission Control Process Towards a Low-Cost, Clean Coal Technology

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Ammonia-based post-combustion CO2 and SO2 integrating capture using multi-stage solvent circulation process

Development and testing of a new post-combustion CO2 capture solvent in pilot and demonstration plant

An integrated de-carbonization supercritical coal-fired power plant incorporating a supplementary steam turbine, process heat recovery and a modified boiler structure

Economic Analysis of CO2 Separation from Coal-Fired Flue Gas by Chemical Absorption and Membrane Absorption Technologies in China

Modeling and Economic Analysis on Combined Capture of CO2 and SO2 in Flue Gas Using Aqueous Ammonia

Progress in Low Carbon Technologies for Large-Scale Coal-Fired Power Plants

Integration of Power Plant and Amine Scrubbing to Reduce CO2 Capture Costs

A New Approach to Control of CO 2 Emission and Optimal Use of C and H for Production of Desired Syngas from Coal

Comprehensive 3E Analysis and Multi-Objective Optimization of a Novel Process for CO2 Capture and Separation Process from Syngas

Technology Development and Cost Analysis of Multiple Pollutant Abatement for Ultra-Low Emission Coal-Fired Power Plants in China

Reducing initial barriers for CCS deployment on pulverized coal-fired power plants in China by optimizing the capture ratio of carbon dioxide

Micro/nanofluid-based Carbon-Negative Process for Capturing CO2 from Low-Carbon Flue Gas to Produce Soda Ash: Effects and Enhancement Mechanisms

Aqueous Ammonia Based Post Combustion Capture: Results from Pilot Plant Operation, Challenges and Further Opportunities

A Feasible Process for Simultaneous Removal of CO2, SO2 and NOx in the Cement Industry by NH3 Scrubbing

Modeling and parametric analysis of nitrogen and sulfur oxide removal from oxy-combustion flue gas using a single column absorber

Industrial test of post combustion CO2 capture by reactive absorption with two new solvents in natural gas power plant

Multistage Circulation Absorption Improvement: Simulation and Energy-Saving Evaluation of an Innovative Amine-Based CO2 Capture Process

Optimization of Carbon Capture Process Using Aqueous Ammonia with Rate-Based Simulation Method

Optimized Fluegas Denitrification Control Strategy to Enhance SCR Performance During Load-Cycling Transient Processes in Coal-Fired Power Plants