Abstract:RF-MEMS is one of the most potential applications for MEMS products. Eutectic solder wafer bonding is one of the attractive methods for RF-MEMS wafer level packaging. A process of gold-tin hermetical wafer bonding was developed in SAIT, Korean. Different UBM systems and thin films of gold-tin were deposited on cap wafer, RF-MEMS device wafer and substrate wafer (if needed). The bonding was performed in N2 ambience with pressure. The cross section of bonding layer had been studied using SEM/EDAX. The thickness of bonding layer is uniform, ranging from 5mum to 7mum. Pretreatment is important to obtain good adhesion and successful microstructure. Voids could be detected without ashing. Optimal process, such as plasma cleaning, would eliminate these voids. There existed different regions in the bonding layer due to inter-diffusion between Au-Sn and other elements. Different intermetallic formed at the bonding layer. The compositions of the intermetallic was identified by EDAX and analyzed according to the Au-Sn phase diagram. The microstructures of the bonding layer are similar for different bonding temperatures in experiments, which indicates lower bonding temperature can get the same hermetical sealing. Typically, there are Au rich layer, AuSn IMC layer and Sn/Au-Ni-Ti layer in the bonding layer between cap wafer and substrate wafer, while there are Au layer, Au-Sn-Ni compound layer in the bonding layer between device wafer and substrate wafer. From the EDAX analysis, different intermetallic compound (IMC) can be identified as AuSn2, AuSn and other composition. Hermetical and shear strength test were performed for as-bonded dice. The test results indicated there is little difference among different bonding process. Fracture surfaces after shear test were investigated as well. The fracture was inside Au-Sn IMC. It indicates the UBM selected is suitable for application. Reliability test was also performed

Evaluation of Au/a-Si eutectic wafer level bonding process

Reliability of Au-Si Eutectic Bonding

Research on Silicon-Glass Thermal Bonding with SiO2 Film Assist

Au-Si Eutectic Wafer Bonding Mechanism Analysis and a Intensity Model

Investigation of Au/Si Eutectic Wafer Bonding for MEMS Accelerometers

Research on Silicon-Glass Direct Bonding at Room Temperature

Au-Si Eutectic Bonding Technology for MEMS Device

Low Temperature Au-In-Au Metallic Bonding and Its Application in the Fabrication of Vcsels

AN INTENSITY TESTING MODEL AND EXAMINATION OF GOLD–SILICON WAFER BONDING

Discussion and Analysis of Au/a-Si Contact Resistance in MEMS/NEMS Devices.

Wafer Lever Packaging for Gyroscope by Au/Si Eutectic Bonding

Silicon-Silicon Anodic Bonding Process With Embedded Glass

A novel method of anodic bonding

Electrical interconnect in MEMS/NEMS devices by Au/a-Si eutectic reaction

Investigation on the bonding quality of GaN and Si wafers bonded with Mo/Au nano-layer in atmospheric air

Evaluation method for MEMS silicon-glass anodic bonding process

Low Temperature Fine Pitch Au-In Solid Liquid Inter Diffusion Bonding for Wafer Level Packaging

Effect of Combined Hydrophilic Activation on Interface Characteristics of Si/Si Wafer Direct Bonding

Study on the mechanism of glass-SiC-glass anodic bonding process

Room temperature bonding of diamond/Si with Mo/Au interlayers in atmospheric air

Microstructure of AuSn Wafer Bonding for RF-MEMS Packaging