Abstract:The simultaneous increase in strength and plasticity of aluminum and its alloys at cryogenic temperatures has been shown in previous research, but the deformation mechanism was still unclear. Therefore, the purpose of this investigation was to reveal the relationship between slip behavior and mechanical response at low temperatures. A quasi-in situ scanning electron microscope was used to observe the evolution of slip bands in the selected aluminum single crystals with two typical orientations at 25 °C, -100 °C, and -180 °C. The results showed that irrespective of orientation, the density of the slip plane was increased with the decline in temperature, which inhibited slip localization and significantly improved plasticity and work hardening. In detail, at RT, the slip bands were widening until the micro-cracks were generated, causing early failure during deformation. When the temperature was decreased to -180 °C, the slip plane density was increased, and the deformation was more homogenous. Moreover, the slip mode was influenced by orientation and temperature. In particular, a single slip system was activated in the sample with the [112] orientation at all the temperatures investigated. Multiple slip systems were found to activate at 25 °C and -100 °C, and only the primary slip system was activated in the sample with [114] orientation at -180 °C. These findings deepen the understanding of slip behavior at cryogenic temperatures, providing new insights into the deformation mechanism of aluminum and its alloys.

Orientation dependence characteristics of microstructures and boundary angle distribution in cold rolled high purity aluminum

MICROSTRUCTURES AND BOUNDARY DISTRIBUTIONS IN Al POLYCRYSTALS ROLLED AT DIFFERENT TEMPERATURES

EVOLUTION OF LOCAL ORIENTATIONS WITHIN INDIVIDUAL GRAINS IN ROLLED PURE POLYCRYSTALLINE ALUMINUM

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

Microstructures and textures in cold-rolled aluminium strip

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium

Evolution of microstructure and local crystallographic orientations in rolled Al 1% Mn single crystals of {l_brace} 0 0 1 {r_brace}< 1 1 0> orientation

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Effect of Microstructures on the Anisotropy of the Roll Casting Strip of Cold Rolled 3003 Aluminum Alloy

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Rolled Aluminium

Slip-induced mechanism of the orientation-dependent deformation banding in cold rolled Al-Mg alloy

Oriented Nucleation Causing Unusual Texture Transition During Static Recrystallization Annealing in Cold-Rolled Mg–Zn–Gd Alloys

Effect of Particles on Microstructural Evolution During Cold Rolling of the Aluminum Alloy AA3104

Evolution Of Microstructure And Local Crystallographic Orientations In Rolled Al-1%Mn Single Crystals Of {001}< 110 > Orientation

Temperature-Induced Variations in Slip Behavior of Single Crystal Aluminum: Microstructural Analysis

Faceting and Migration of Low Angle <100> Tilt Grain Boundaries in Pure Aluminum

Effect of Rolling and Annealing on Microstructure and Mechanical Properties of High Purity Aluminum

In-situ Study of the Effect of Strain Path Change on Dislocation Boundary Evolution in Commercial Purity Aluminum

Anisotropic Tensile Behavior and Related Yield Point Phenomena in Annealed Ultrafine-Grained Pure Aluminum

Micro-process of Cube Texture Formation in High Purity Aluminum Foils by Cross Shear Rolling