Abstract:The recrystallization process in 1565 ch aluminium alloy samples was studied in this paper. Existing and well-studied AA5182 aluminium alloy was also investigated for comparison. Samples of both alloys were cut from pre-homogenized ingots and rolled in different modes. After rolling the samples were annealed at different temperatures and the resulting microstructure was studied using scanning electron microscopy and optical microscopy, as well as EBSD (Electron backscatter diffraction) analysis. The study revealed significant differences in the recrystallization processes of these two alloys. Signs of the recrystallization onset without grain growth process can be observed at 10% deformation in 1565 ch alloy. At the same time signs of recrystallization in AA5182 can been observed only when the degree of deformation is over 30%, but the process itself is much faster. 5182 alloy fully recrystallizes after all hot rolling schedules, except for those with 10% deformation. In such case recrystallization timing as a function of Zener-Hollomon parameter and prior strain level ranges from a few seconds to half an hour. In major cases 1565 ch alloy has partially recrystallized structure, which takes 10 to 95 volume %. Exception is the schedule with deformation 50% and Zener parameter 1.77 × 1015, where full recrystallization occurs. With such strain parameters 1565 alloy grain size reaches 6–14 μm. At the same time similar processing provides larger grain size in 5182 alloy, it reaches 10–20 μm. Substructure review immediately after deformation demonstrated, that cellular polygonised structure forms faster in 1565 ch alloy, which can be explained by higher magnesium content. In both cases PSN nucleation mechanism prevails. However, other grain nucleation mechanisms can be observed in 5182 alloy. The main reasons for the abovementioned phenomenon are different magnesium contents and volumes of fine secondary phases.

In-Situ Observations of Migration of Recrystallization Boundaries in Pure Aluminium

Local Boundary Migration During Recrystallization in Pure Aluminium

Nanostructured Aluminium - Recovery And Recrystallization

Boundary Migration During Recrystallization of Heavily Deformed Pure Nickel

In-situ Study of the Effect of Strain Path Change on Dislocation Boundary Evolution in Commercial Purity Aluminum

Investigation of Boundary Migration During Grain Growth in Fully Recrystallised High Purity Nickel

MICROSTRUCTURES AND BOUNDARY DISTRIBUTIONS IN Al POLYCRYSTALS ROLLED AT DIFFERENT TEMPERATURES

In-situ observations of static recrystallization and texture formation in a cold-rolled CoCrFeMnNi high entropy alloy

Study of the recrystallization behaviour of the aluminium 1565ch alloy during hot rolling of the as cast structures

Recovery and Recrystallization in Commercial Purity Aluminum Cold Rolled to an Ultrahigh Strain

3d Characterization Of Recrystallization Boundaries

Measurements of the Curvature of Protrusions/Retrusions on Migrating Recrystallization Boundaries

Advancement In Characterization And Modeling Of Boundary Migration During Recrystallization

Boundary Migration in a 3D Deformed Microstructure Inside an Opaque Sample

Direct Observation of Nucleation in the Bulk of an Opaque Sample

Evolution of Microstructure and Texture During Recovery and Recrystallization in Heavily Rolled Aluminum

Recrystallization behavior and texture evolution during annealing of cryogenic-rolled 3003 aluminum alloy

Dislocation substructures in pure aluminium after creep deformation as studied by electron backscatter diffraction

Non-uniform Grain Boundary Migration During Static Recrystallization: A Cellular Automaton Study

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

Strain Distribution and Lattice Rotations During In-Situ Tension of Aluminum with a Transmodal Grain Structure