Abstract:Samples of aluminum were prepared using spark plasma sintering from a mixture of coarse (average particle size of 6 mu m) and fine (average particle size of 1 mu m) powders to achieve a heterogeneous transmodal grain size distribution covering a range of grain sizes from approximate to 1 to 10 mu m. By careful choice of surface markers both electron back-scatter diffraction (EBSD) data, to track crystal rotations, and digital image correlation (DIC) data, to track local plastic deformation, were collected from the same region during in-situ tensile deformation up to a strain of epsilon t = 0.126. A heterogeneous pattern of crystal rotation is observed for all grain sizes, although in some smaller grains (defined as those <4 mu m diameter) no clear grain sub-division was identified. Plastic strain was more concentrated in the larger grains, but the average rotation rate of the smaller grains was found to be higher than that of larger grains, showing also a much wider spread in rotation rate. Based on the change in average orientation, a clear orientation dependence in the tensile axis rotation direction was observed for many larger grains, in agreement with previously reported data for aluminum with average grain size of 75 mu m, whereas the smaller grains showed a more complex rotation behavior, with more of these grains showing unexpected tensile axis rotations. The combination of both EBSD and DIC during in-situ experiments provides a rich data set for analysis of plastic deformation in samples with a heterogeneous microstructure.

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Effect of Particles on Microstructural Evolution During Cold Rolling of the Aluminum Alloy AA3104

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Rolled Aluminium

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Microstructure and Texture Evolution of Particle-Containing Aa3104 Alloy Cold Rolled to Large Strains

MICROSTRUCTURAL EVOLUTION OF COLUMNAR GRAIN Al DURING COLD ROLLING II. Mircoscopic Subdivision

The Grain Size and Orientation Dependence of Geometrically Necessary Dislocations in Polycrystalline Aluminum During Monotonic Deformation: Relationship to Mechanical Behavior

Microstructure–grain Orientation Relationship in Coarse Grain Nickel Cold-Rolled to Large Strain

Orientation dependence of dislocation structure in surface grain of pure aluminium deformed in tension

Study of Dislocation Boundary Structure in Al–Li Alloy During Bending

Effect of second-phase precipitates on deformation microstructure in AA2024 (Al–Cu–Mg): dislocation substructures and stored energy

In-situ Study of the Effect of Strain Path Change on Dislocation Boundary Evolution in Commercial Purity Aluminum

MICROSTRUCTURES AND BOUNDARY DISTRIBUTIONS IN Al POLYCRYSTALS ROLLED AT DIFFERENT TEMPERATURES

Slip-induced mechanism of the orientation-dependent deformation banding in cold rolled Al-Mg alloy

EVOLUTION OF LOCAL ORIENTATIONS WITHIN INDIVIDUAL GRAINS IN ROLLED PURE POLYCRYSTALLINE ALUMINUM

Cell Structures in Rolled Aluminium and Nickel

Strain Distribution and Lattice Rotations During In-Situ Tension of Aluminum with a Transmodal Grain Structure

Orientation Dependence of the Deformation Microstructure of Ta-4% W after Cold-Rolling

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling