Abstract:The deformation behavior in polycrystalline Laser melting deposited (LMD) TA15 alloy was investigated at a temperature of 500 degrees C using advanced in-situ Secondary electron microscopy (SEM) tensile setup coupled with Electron backscatter diffraction (EBSD). The grains morphology, crystal orientation, preferred pole texture, activated slip traces, grain boundaries evolution, and strain-induced misorientation were systematically analyzed during tensile straining. It was determined that the diverse alpha-grains (crystal orientation and morphology) revealed inhomogeneous deformation under tensile loading. The overall strain was allocated by grain rotation and substructure formation. The preferred oriented (0001) pole texture maximum was increased during initial strain level. In contrast, at higher strain, the texture intensity was decreased due to the formation and relocation of the newly formed substructures. The fraction of low angle grain boundaries (LAGBs 2-10 degrees) was increased continually with increasing strain. Strain-induced dislocations within larger grains formed new LAGBs, and the increasing fraction of LAGBs was validated by Kernel average misorientation (KAM) map. The prismatic slip mode was identified as the primary active slip system at the initial deformation stage. The fraction of basal and pyramidal < a > slips increased as the strain increased, describing the opposite trend to prismatic slip. The grains rotation and strain accumulation at the grain boundaries accommodated the plastic deformation, ultimately causing boundary sliding.

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Microstructure and Texture Evolution of Particle-Containing Aa3104 Alloy Cold Rolled to Large Strains

Development of Microstructures and Texture During Cold Rolling in AA 7055 Aluminum Alloy

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Evolution of texture and microstructure of 2E12 aluminum alloy during cold rolling and annealing

Study of Texture in 6016 Aluminum Alloy During Processing

Temperature Dependence of Microstructure and Texture in Cold Drawn Aluminum Wire

Evolution of Microstructure and Texture During Recovery and Recrystallization in Heavily Rolled Aluminum

Microstructural and texture evolution investigation of laser melting deposited TA15 alloy at 500?C using in-situ EBSD tensile test

Relevance Between Microstructure and Texture During Cold Rolling of AA3104 Aluminum Alloy

Large Strain Deformation and Annealing of Aluminium

Effect of Accumulative Roll Bonding Process on Textural Evolution and Its Comparison with Normal Rolled AA7005 Aluminum Alloy

Evolution of Microstructures and Textures of High Purity Aluminium During Rolling and Annealing

Texture Evolution in an Al-Cu-Mg Alloy During Hot Rolling

Texture Evolution of Al-Zn-Mg-Cu Aluminum Alloy Plate During Cold Rolling

Recovery of heavily cold-rolled aluminum: Effect of local texture

Through-Thickness Characterization of Microstructure and Texture in High Purity Aluminum Processed to High Strain by Accumulative Roll-Bonding

Texture Evolution of Al-Mg-Li Aeronautical Alloys in In-Situ Tension

Recrystallization Microstructure and Texture of Highly Strained Commercial Purity Aluminium Alloy

Microtextural Evolution of Different TRC AA8006 Alloy Sections with Homogenization

Deformation and Recrystallization Textures in Straight-Rolled and Pseudo Cross-Rolled AA 3105 Aluminum Alloy