Abstract:Recovery and recrystallization were studied in commercial purity aluminum cold rolled to an ultrahigh strain (εvM=6.4) and isothermally annealed at 300°C. The deformed material consists of three layers with similar fractions of high-angle boundaries (HABs) and similar lamellar boundary spacings, but with different textures and different spatial arrangements of the rolling texture components. Annealing leads initially to a coarsening of the lamellar microstructure, accompanied by a reduction in the HAB fraction. Ex-situ experiments using very short annealing times indicate that such microstructural changes are consistent with a process of coarsening via triple junction motion. The recovery proceeds similarly in the center and subsurface layers, but because of the different initial spatial arrangement of the texture components in these layers, the loss of HABs is significantly greater in the subsurface compared with the center layer. Further annealing leads to discontinuous recrystallization, which occurs differently in the center and subsurface layers. In the center layer, recrystallization proceeds more rapidly and with a larger frequency of nuclei, resulting in a smaller recrystallized grain size. In contrast, pronounced recrystallization in the subsurface layers is delayed, and the recrystallized grain size is larger than in the center. It is concluded that the changes taking place during recovery are very significant in determining the subsequent recrystallization behavior in terms of the final grain size and texture.

Annealing Behavior of Nanostructured Aluminum Produced by Cold Rolling to Ultrahigh Strains

Nanostructured Aluminium - Recovery And Recrystallization

Thermal Stability of Aluminum Cold Rolled to Large Strain

Annealing Behavior of Accumulative Roll Bonding Processed Aluminum Composites

Large Strain Deformation and Annealing of Aluminium

Microstructural Coarsening During Annealing of Cold Rolled Aluminum

Quantification of Annealed Microstructures in ARB Processed Aluminum

Evolution of Microstructure and Texture During Recovery and Recrystallization in Heavily Rolled Aluminum

Microstructural Parameter-Based Characterization of Annealing Behaviour in Metals Deformed to High Strains

Effects of annealing treatment on mechanical properties of 8011 aluminum alloy after cryogenic rolling

Effect of Annealing Temperature on Recrystallisation in Al (AA1200) Cold Rolled to a True Strain of 4

Linking Recovery and Recrystallization Through Triple Junction Motion in Aluminum Cold Rolled to a Large Strain

Effects of Cold Rolling and Heat Treatment on Microstructure and Mechanical Properties of AA 5052 Aluminum Alloy

Significant annealing-induced hardening effect in nanolaminated-nanotwinned (CrCoNi)97.4Al0.8Ti1.8 medium-entropy alloy by severe cold rolling

Effects of Annealing on Microstructure and Mechanical Properties of Nano-Grained Ni-Based Alloy Produced by Severe Cold Rolling

Influence of alloy chemistry on the deformation behaviour and anisotropic properties of aluminium ultra-fine-grained thin sheets

Annealing Behavior of 6061 Al Alloy Subjected to Differential Speed Rolling Deformation

Tailoring structures through two-step annealing process in nanostructured aluminum produced by accumulative roll-bonding

Recovery and Recrystallization in Commercial Purity Aluminum Cold Rolled to an Ultrahigh Strain

Effect of Annealing Treatment on the Microstructure and Mechanical Properties of Ultrafine-Grained Aluminum

Recovery of heavily cold-rolled aluminum: Effect of local texture