Abstract:The research on Al–Zn–Mg–Cu alloys mainly focuses on the effects of solution aging and strain rate on the microstructure and properties of the alloy, as well as the flow stress behavior of the alloy. There are few studies on the effects of hot rolling deformation and reduction pass on the microstructure and properties of aluminum alloy. The dislocation density of alloy is affected by changing the rolling deformation, and post-heat treatment improves fine grains segregation and break coarse second phases. The alloys comprehensive mechanical properties are improved by controlling the recrystallization fraction and size. Different shape variable rolling and different passes, optical microscope (OM), field emission scanning electron microscope (SEM) with energy dispersive spectrometers (EDS), X-ray diffractometer (XRD), microhardness tester, and other methods were used to characterize the samples, and simulation of the rolling process analyzed by Deform-3D software. The effects of hot rolling deformation and deformation pass on microstructure and properties of aluminum alloy were also studied. The results show that dynamic recrystallization was beneficial to grain refinement when deformation increases to 40%. The coarse second phase was broken and refined into chains and partially spheroidized to dissolve in the matrix under large deformation. Dislocation density decreased after solution treatment when deformation was less than 80%, and increased after large deformation was 80%. The equivalent strain obtained by numerical simulations increases with the increase of deformation. The maximum equivalent strain was on both sides of the rolling surface, and this area was the most prone to crack in rolling. When the increase of the shape variable, the recrystallization volume fraction increased, and the grain size decreased.

Effect of Rolling and Annealing on Microstructure and Mechanical Properties of High Purity Aluminum

Effect of Annealing Process on Microstructure and Properties of Rolled Semi-solid Billet

Effects Of Rolling Process On Microstructure And Mechanical Property Of 7050 Aluminum Alloy

Thermal Stability of Aluminum Cold Rolled to Large Strain

Effect of annealing process on microstructure and mechanical properties of precipitated phase of A1235 aluminum alloy

Annealing Behavior of Nanostructured Aluminum Produced by Cold Rolling to Ultrahigh Strains

Effect of Annealing Process on the Microstructure and Texture of Cold-Rolled High-Purity Al-0.5%Cu Plates

Effects of annealing treatment on mechanical properties of 8011 aluminum alloy after cryogenic rolling

Effect of Alloying Elements and Processing Parameters on Microstructure and Properties of 1XXX Aluminium Alloys

Microstructural Evolution and Mechanical Properties of Pure Aluminum upon Multi-Pass Caliber Rolling

The effect of annealing temperature on the recrystallization and mechanical properties of severe plastic deformed commercial pure aluminium during ultra-fast annealing

Effect of rolling deformation and passes on microstructure and mechanical properties of 7075 aluminum alloy

Effect of Initial Microstructure on the Hot Deformation Behavior and Microstructure Evolution of Aluminum Alloy AA2060

Effect of Annealing on the Microstructure, Texture, and Properties of Cold-Rolled Ti50Ni47Fe3 Shape Memory Alloy Sheets

Effect of Annealing Treatment on the Mechanical Properties and Corrosion Behaviors of 01570 Aluminum Alloy

Effect of cold rolling on microstructure and mechanical properties of pure Zr

Effect of recrystallization annealing, solid solution and pre-aging intermediate treatment on microstructure and mechanical properties of Al-Mg-Si rolled sheet

The Influence of Annealing on the Microstructural and Textural Evolution of Cold-Rolled Er Metal

Effect of heat treatment on the microstructure and mechanical properties of cryogenic rolling 2195 Al–Cu–Li alloy

The Effects of Rolling Deformation and Annealing Treatment on Damping Capacity of 1200 Aluminium Alloy

Effect of Residual Deformation Energy and Critical Heating Rate on Cubic Texture and Grain Growth Behavior of Severely Deformed Aluminum Foil