Abstract:In this study, the crystal plasticity finite element method was established by coupling the crystal plasticity and finite element method (FEM). The effect of rolling deformation and slip system of polycrystalline Al-Mg-Si aluminum alloy was investigated. The results showed that there was a pronounced heterogeneity in the stress and strain distribution of the material during cold rolling. The maximum strain and shear strain occurred at surface of the material. The smaller the grain size, the lower the strain concentration at the grain boundary. Meanwhile, a smaller strain difference existed between the grain interior and near the boundary. The rotation of grains leads to significant differences in deformation and rotation depending on their initial orientations during the rolling process. The slip system of (11-1)<-110> had a large effect on the plastic deformation, (111)<10-1> is second, and the effect of (1-11)<011> slip system on the plastic deformation is the smallest. After deformation, the grain orientation concentration was increased with deformation. Therefore, both the strength and volume fraction of texture were increased with the increase in rolling deformation. The experimental results of EBSD indicated that the large rolling reduction resulted in severe grain twisting, so the texture strength was increased. The simulation results were in close agreement with the experimental results. This study provides a theoretical basis for the rolling process, microstructure, and performance control of aluminum alloys.

MICROSTRUCTURAL EVOLUTION OF COLUMNAR GRAIN Al DURING COLD ROLLING II. Mircoscopic Subdivision

Evolution of Orientations and Deformation Structures Within Individual Grains in Cold Rolled Columnar Grained Nickel

Experimental Observation and Modelling of the Orientation Evolution of Individual Grains in Columnar Grain Ni During Cold Rolling

Texture and Deformation Structure Evolution During Rolling of Individual Grains of Columnar Grain Nickel

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Evolution of microstructure and local crystallographic orientations in rolled Al 1% Mn single crystals of {l_brace} 0 0 1 {r_brace}< 1 1 0> orientation

Investigation of Macroscopic Grain Sub-Division of an IF-Steel During Cold-Rolling

Macroscopic Subdivision Of Columnar Grain Aluminium With {001} < U Upsilon 0 > Orientations Following Low Strain Deformation

Subdivision of Original Grains During Cold-Rolling of Interstitial-Free Steel

Microstructure–grain Orientation Relationship in Coarse Grain Nickel Cold-Rolled to Large Strain

Evolution Of Microstructure And Local Crystallographic Orientations In Rolled Al-1%Mn Single Crystals Of {001}< 110 > Orientation

Effect of Particles on Microstructural Evolution During Cold Rolling of the Aluminum Alloy AA3104

Macroscopic subdivision of columnar grain aluminium with ?0 0 1?〈u v 0〉 orientations following low strain deformation

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

Local Texture Evolution during Rolling Deformation of Single Crystals of {100} Orientation

Macroscopic Sub-Division of Rolled Al–1%Mn Single Crystals of {0 0 1}〈110〉 Orientation

EVOLUTION OF LOCAL ORIENTATIONS WITHIN INDIVIDUAL GRAINS IN ROLLED PURE POLYCRYSTALLINE ALUMINUM

Microstructure and Texture Evolutions of Aa1050 Aluminum Alloy Cold Rolled to High Strains

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

MICROSTRUCTURES AND BOUNDARY DISTRIBUTIONS IN Al POLYCRYSTALS ROLLED AT DIFFERENT TEMPERATURES

The effect of grain size on texture evolution and mechanical properties of an AZ31 magnesium alloy during cold-rolling process