Abstract:Samples of aluminum were prepared using spark plasma sintering from a mixture of coarse (average particle size of 6 mu m) and fine (average particle size of 1 mu m) powders to achieve a heterogeneous transmodal grain size distribution covering a range of grain sizes from approximate to 1 to 10 mu m. By careful choice of surface markers both electron back-scatter diffraction (EBSD) data, to track crystal rotations, and digital image correlation (DIC) data, to track local plastic deformation, were collected from the same region during in-situ tensile deformation up to a strain of epsilon t = 0.126. A heterogeneous pattern of crystal rotation is observed for all grain sizes, although in some smaller grains (defined as those <4 mu m diameter) no clear grain sub-division was identified. Plastic strain was more concentrated in the larger grains, but the average rotation rate of the smaller grains was found to be higher than that of larger grains, showing also a much wider spread in rotation rate. Based on the change in average orientation, a clear orientation dependence in the tensile axis rotation direction was observed for many larger grains, in agreement with previously reported data for aluminum with average grain size of 75 mu m, whereas the smaller grains showed a more complex rotation behavior, with more of these grains showing unexpected tensile axis rotations. The combination of both EBSD and DIC during in-situ experiments provides a rich data set for analysis of plastic deformation in samples with a heterogeneous microstructure.

Macroscopic subdivision of columnar grain aluminium with ?0 0 1?〈u v 0〉 orientations following low strain deformation

Macroscopic Subdivision Of Columnar Grain Aluminium With {001} < U Upsilon 0 > Orientations Following Low Strain Deformation

MICROSTRUCTURAL EVOLUTION OF COLUMNAR GRAIN Al DURING COLD ROLLING II. Mircoscopic Subdivision

Macroscopic Sub-Division of Rolled Al–1%Mn Single Crystals of {0 0 1}〈110〉 Orientation

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Evolution of microstructure and local crystallographic orientations in rolled Al 1% Mn single crystals of {l_brace} 0 0 1 {r_brace}< 1 1 0> orientation

Evolution of Orientations and Deformation Structures Within Individual Grains in Cold Rolled Columnar Grained Nickel

Evolution Of Microstructure And Local Crystallographic Orientations In Rolled Al-1%Mn Single Crystals Of {001}< 110 > Orientation

Microstructure–grain Orientation Relationship in Coarse Grain Nickel Cold-Rolled to Large Strain

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

The Grain Size and Orientation Dependence of Geometrically Necessary Dislocations in Polycrystalline Aluminum During Monotonic Deformation: Relationship to Mechanical Behavior

Influence of Grain Size in the Near-Micrometre Regime on the Deformation Microstructure in Aluminium

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Rolled Aluminium

Orientation dependence of dislocation structure in surface grain of pure aluminium deformed in tension

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium

Macro deformation twins in single-crystal aluminum

Strain Distribution and Lattice Rotations During In-Situ Tension of Aluminum with a Transmodal Grain Structure

Deformation induced columnar grain rotation in nanotwinned metals

Texture and Deformation Structure Evolution During Rolling of Individual Grains of Columnar Grain Nickel

Grain Structure and Microtexture Evolution During Superplastic Deformation of 5A90 Al-Li Alloy

Slip Pattern, Microstructure and Local Crystallography in an Aluminium Single Crystal of Copper Orientation {112}〈111〉