Abstract:Samples of aluminum were prepared using spark plasma sintering from a mixture of coarse (average particle size of 6 mu m) and fine (average particle size of 1 mu m) powders to achieve a heterogeneous transmodal grain size distribution covering a range of grain sizes from approximate to 1 to 10 mu m. By careful choice of surface markers both electron back-scatter diffraction (EBSD) data, to track crystal rotations, and digital image correlation (DIC) data, to track local plastic deformation, were collected from the same region during in-situ tensile deformation up to a strain of epsilon t = 0.126. A heterogeneous pattern of crystal rotation is observed for all grain sizes, although in some smaller grains (defined as those <4 mu m diameter) no clear grain sub-division was identified. Plastic strain was more concentrated in the larger grains, but the average rotation rate of the smaller grains was found to be higher than that of larger grains, showing also a much wider spread in rotation rate. Based on the change in average orientation, a clear orientation dependence in the tensile axis rotation direction was observed for many larger grains, in agreement with previously reported data for aluminum with average grain size of 75 mu m, whereas the smaller grains showed a more complex rotation behavior, with more of these grains showing unexpected tensile axis rotations. The combination of both EBSD and DIC during in-situ experiments provides a rich data set for analysis of plastic deformation in samples with a heterogeneous microstructure.

Evolution of microstructure and local crystallographic orientations in rolled Al 1% Mn single crystals of {l_brace} 0 0 1 {r_brace}< 1 1 0> orientation

Evolution Of Microstructure And Local Crystallographic Orientations In Rolled Al-1%Mn Single Crystals Of {001}< 110 > Orientation

Macroscopic Sub-Division of Rolled Al–1%Mn Single Crystals of {0 0 1}〈110〉 Orientation

Local Texture Evolution during Rolling Deformation of Single Crystals of {100} Orientation

Structural, Magnetic and Mechanical Properties of Oligocrystalline Ni-Mn-Ga Shape Memory Microwires

MICROSTRUCTURAL EVOLUTION OF COLUMNAR GRAIN Al DURING COLD ROLLING II. Mircoscopic Subdivision

Microstructure–grain Orientation Relationship in Coarse Grain Nickel Cold-Rolled to Large Strain

MICROSTRUCTURES AND BOUNDARY DISTRIBUTIONS IN Al POLYCRYSTALS ROLLED AT DIFFERENT TEMPERATURES

EVOLUTION OF LOCAL ORIENTATIONS WITHIN INDIVIDUAL GRAINS IN ROLLED PURE POLYCRYSTALLINE ALUMINUM

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Evolution of Orientations and Deformation Structures Within Individual Grains in Cold Rolled Columnar Grained Nickel

Slip Pattern, Microstructure and Local Crystallography in an Aluminium Single Crystal of Copper Orientation {112}〈111〉

Deformation And Annealing Textures Of Extruded And Cold Rolled Pure Ni Single Crystals Of Cube Orientation

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium

Strain Distribution and Lattice Rotations During In-Situ Tension of Aluminum with a Transmodal Grain Structure

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Rolled Aluminium

Deformation mechanism, orientation evolution and mechanical properties of annealed cross-rolled Mg-Zn-Zr-Y-Gd sheet during tension

Orientation Dependence of the Deformation Microstructure of Ta-4% W after Cold-Rolling

Macroscopic Subdivision Of Columnar Grain Aluminium With {001} < U Upsilon 0 > Orientations Following Low Strain Deformation

Lattice Rotation and Deformation Mechanisms under Tensile Loading in a Single-Crystal Superalloy with [001] Misorientation