Abstract:In this study, the crystal plasticity finite element method was established by coupling the crystal plasticity and finite element method (FEM). The effect of rolling deformation and slip system of polycrystalline Al-Mg-Si aluminum alloy was investigated. The results showed that there was a pronounced heterogeneity in the stress and strain distribution of the material during cold rolling. The maximum strain and shear strain occurred at surface of the material. The smaller the grain size, the lower the strain concentration at the grain boundary. Meanwhile, a smaller strain difference existed between the grain interior and near the boundary. The rotation of grains leads to significant differences in deformation and rotation depending on their initial orientations during the rolling process. The slip system of (11-1)<-110> had a large effect on the plastic deformation, (111)<10-1> is second, and the effect of (1-11)<011> slip system on the plastic deformation is the smallest. After deformation, the grain orientation concentration was increased with deformation. Therefore, both the strength and volume fraction of texture were increased with the increase in rolling deformation. The experimental results of EBSD indicated that the large rolling reduction resulted in severe grain twisting, so the texture strength was increased. The simulation results were in close agreement with the experimental results. This study provides a theoretical basis for the rolling process, microstructure, and performance control of aluminum alloys.

Cell Structures in Rolled Aluminium and Nickel

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

Evolutions of Grain Orientation and Dislocation Boundary in Aa1050 Aluminum Alloy During Cold Rolling from Low to Medium Strains

Structural evolution and dislocation behaviour during nano-rolling process of FCC metals: A molecular dynamics simulation based investigation

Evolution of Orientations and Deformation Structures Within Individual Grains in Cold Rolled Columnar Grained Nickel

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Rolled Aluminium

Texture and Deformation Structure Evolution During Rolling of Individual Grains of Columnar Grain Nickel

Deformation And Annealing Textures Of Extruded And Cold Rolled Pure Ni Single Crystals Of Cube Orientation

MICROSTRUCTURAL EVOLUTION OF COLUMNAR GRAIN Al DURING COLD ROLLING II. Mircoscopic Subdivision

In-Situ Observations of Migration of Recrystallization Boundaries in Pure Aluminium

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium

The correlation between slip systems and dislocation structures in tensile-rolled nickel

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

The Effect of Size on Dislocation Cell Formation and Strain Hardening in Aluminium

Grain Growth Mechanism of Lamellar-Structure High-Purity Nickel via Cold Rolling and Cryorolling during Annealing

Microstructure–grain Orientation Relationship in Coarse Grain Nickel Cold-Rolled to Large Strain

Effect of Particles on Microstructural Evolution During Cold Rolling of the Aluminum Alloy AA3104

Development of the Cube Texture at Low Annealing Temperatures in Highly Rolled Pure Nickel

Orientation dependence of dislocation structure in surface grain of pure aluminium deformed in tension

Microstructure Evolution and Texture Characteristics of Pure Nickel N6 During Cold Rolling Process

MICROSTRUCTURES AND BOUNDARY DISTRIBUTIONS IN Al POLYCRYSTALS ROLLED AT DIFFERENT TEMPERATURES