Abstract:The evolution of microstructure and texture of CuCrZr sheet is studied during cryogenic rolling. It indicates that the grains of CuCrZr alloy rolled both at room temperature and at cryogenic temperature are elongated along the rolling direction. After annealing, the grains become equiaxed with a little smaller of cryogenic rolling than that of room temperature rolling. On the other hand, as the rolling reduction increases, the dislocation density increases with a feature of twinning deformation during deep cold rolling, which results of the texture of CuCrZr alloy during cryogenic rolling occurred mainly with composition of Goss {011} texture and Brass {011} texture accompanied by a strong Taylor {44 11} and Copper {112} textures. Meanwhile, R {124} and S {123} textures also appear on the section of φ2 = 65°. With the increase of processing reduction, twinning deformation is occurred, and Goss {011} orientation continues to flow to Brass {011} orientation, with no change in the strength of Copper and Taylor textures. However, the strength of R {124} and S {123} textures gradually increase, but the increase is smaller than the main Brass {011} orientation so that the yield strength, tensile strength and uniform elongation of CuCrZr alloy sheet prepared by cryogenic rolling are higher than those of room temperature cold rolling at the same deformation conditions.

Formation Processes of Dislocation Cells in Cryorolled Zr Upon Annealing

Simultaneously Enhancing the Ductility and Strength of Cryorolled Zr Via Tailoring Dislocation Configurations

Effect of strain rate on microstructure evolutions and mechanical properties of cryorolled Zr upon annealing

Mechanical annealing of cryorolled Zr

Texture Evolution and Temperature-Dependent Deformation Modes in Ambient- and Cryogenic-Rolled Nanolayered Zr-2.5Nb

Effect of cold rolling on microstructure and mechanical properties of pure Zr

Mechanical properties and thermal stability of gradient structured Zr via cyclic skin-pass cryorolling

Effect of Rolling Deformation on the Structure of Bulk Zr60cu30al10 Amorphous Alloy

Extraordinary Toughening by Cryorolling in Zr

Microstructural Evolution and Mechanical Properties in Zr705 During the Rolling Process

Effect of cryogenic rolling on the microstructure and texture of CuCrZr alloy

Microstructures and Mechanical Properties of a Commercial Pure Zirconium during Rolling and Annealing at Different Temperatures

Tensile Deformation and Fracture Behaviours of Cold Rolled Cu-3wt.%Ag-0.5wt.%Zr Thin Sheets with Different Annealed Microstructures

Structure Evolution of Bulk Zr60Cu20Pd10Al10 Amorphous Alloy During Rolling Deformation

Microstructure evolution behavior and mechanical mechanisms in a near α-Zr alloy by cold rolling

INFLUENCE OF A LOW-TEMPERATURE PLASTIC-DEFORMATION PROCESS ON THE MICROSTRUCTURE OF AN Al-Si-Mg ALUMINUM ALLOY

Nanocrystallization of Pure Zr Via Room Temperature Rolling Deformation

Microstructure and properties evolution of Mg–2Y–0.6Nd–0.6Zr alloy rolled at room and liquid nitrogen temperature

Recrystallization behavior and texture evolution during annealing of cryogenic-rolled 3003 aluminum alloy

Microstructural evolution during annealing and rolling Zr52.5Cu17.9Ni14.6Al10Ti5 bulk metallic glass

Revealing the High Strength and High Thermal Stability of a Nano-Lamellar Cu-0.1 At. % Zr Alloy