Abstract:The introduction of twin lamellae and dislocation interaction through Multi-directional forging (MDF) at room temperature (RT) has been reported to significantly improve the mechanical properties of Mg alloys. However, the alloy typically exhibited poor plasticity at RT, making it highly susceptible to cracking. This study further enhanced the deformation capacity of AZ80 alloy by adding a pre-cryogenic step before MDF. Compared to direct MDF at RT, MDF at cryogenic temperature (CT, -196 °C) further increased the alloy's deformation capacity from 0.72 (4P) to 1.08 (6P), with the tensile yield strength (TYS) and ultimate tensile strength (UTS) increasing to ∼420 MPa and ∼512 MPa. The alloy subjected to cryogenic MDF exhibited denser twin lamellae and a higher proportion of {10-12}-{10-12} twin interactions. The more frequent twin interactions under CT inhibited excessive twin growth and further increased the dislocation density of the matrix, facilitating the nucleation of new twins. Additionally, with increasing deformation passes, the texture of the RT specimens became more single, while the CT specimen showed a trend toward texture dispersion. The study elucidated that poor forgeability of the alloy under MDF at RT was hindered by unfavorable texture and limited twin activation. However, this issue was mitigated under CT, where the activation of more atypical twins with low Schmid factors (SFs) significantly enhanced the deformation coordination ability. Furthermore, the activation of atypical twins and extensive twin interactions promoted texture dispersion in CT specimens, which facilitated the activation of various slips and suppressed excessive twinning-induced hardening, thereby improving forgeability.

Simultaneously Enhancing the Ductility and Strength of Cryorolled Zr Via Tailoring Dislocation Configurations

Extraordinary Toughening by Cryorolling in Zr

Effect of strain rate on microstructure evolutions and mechanical properties of cryorolled Zr upon annealing

Mechanical annealing of cryorolled Zr

High Strength and Ductility in Multimodal-Structured Zr

Formation Processes of Dislocation Cells in Cryorolled Zr Upon Annealing

Tailoring Grain Size Distribution for Optimizing Strength and Ductility of Multi-Modal Zr

Enhancing Fracture Toughness of Fine-Grained Zr Via Forming Nanoscale Defect Structures

Mechanical properties and thermal stability of gradient structured Zr via cyclic skin-pass cryorolling

Effect of cold rolling on microstructure and mechanical properties of pure Zr

Texture Evolution and Temperature-Dependent Deformation Modes in Ambient- and Cryogenic-Rolled Nanolayered Zr-2.5Nb

Effect of cryogenic rolling and multistage thermo-mechanical treatment on the microstructure and properties of the Cu-0.4Cr-0.39Zn-0.1Mg-0.07Zr alloy

Superior mechanical properties of pure Zr with heterogeneous structure

Effect of Strain Rate on Microstructure and Mechanical Properties of Electroplastic Rolled ZrTi Alloy

Effect of Rolling Deformation on the Structure of Bulk Zr60cu30al10 Amorphous Alloy

An Extraordinary Enhancement of Strain Hardening in Fine-Grained Zirconium

Microstructural evolution and mechanical property of Cu‐Cr‐Zr‐ZrB2 composites subjected to cryorolling and aging treatment

Effect of cryogenic rolling on the microstructure and texture of CuCrZr alloy

Study on the plasticity improvement mechanism and grain refinement of AZ80 Mg alloy under cryogenic multi-directional forging

Achieving Heterogeneous Structure in Hcp Zr Via Electroplastic Rolling

Deformation mechanism and mechanical properties of a CoCrFeNi high-entropy alloy via room-temperature rolling, cryorolling, and asymmetric cryorolling