Abstract:In the present work, the influence of number of cycles on microstructure, texture and mechanical behavior of Zr702 plates has been systematically studied using the accumulative roll bonding (ARB) method. Electron back-scatter diffraction and transmission electron microscopy have been used to study the development of microstructure and texture. Results show that the {0001} bimodal texture is obvious in all the samples. At the same time, the fiber is weakened and the fiber is strengthened gradually with the increase of ARB cycle number from 1 to 3. In addition, some unbroken coarse grains with c-axis close to normal direction can be observed in ARB samples. The reason for this phenomenon is that the prismatic slips are not easily activated due to unfavorable orientation. The tensile test results along the rolling direction show that the strength increases and the elongation decreases with the increase of ARB cycle number. Compared with the as-received plate sample, the yield strength of ARB sample subjected to 3 cycles is increased by about 99%, while still maintain 7.4% of the elongation to fracture. In order to clarify the mechanical mechanisms during deformation, the back stress hardening caused by the heterostructure mixed with coarse and fine grains and substructure have been discussed in detail. In addition, the calculation results of Schmid factor (SF) show that prismatic slip is the dominant slip mechanism in the deformation process of all samples. However, the average SF value of the basal slip systems decreases with the increasing number of ARB cycles, which maybe another significant factor leading to the change of yield strength.

Mechanical properties and thermal stability of gradient structured Zr via cyclic skin-pass cryorolling

Effect of cold rolling on microstructure and mechanical properties of pure Zr

Extraordinary Toughening by Cryorolling in Zr

A strategy to introduce gradient equiaxed grains into Zr sheet by combining laser surface treatment, rolling and annealing

Microstructures and Mechanical Properties of a Commercial Pure Zirconium during Rolling and Annealing at Different Temperatures

Deformation mechanism, orientation evolution and mechanical properties of annealed cross-rolled Mg-Zn-Zr-Y-Gd sheet during tension

Effect of cryogenic rolling on the microstructure and texture of CuCrZr alloy

Recrystallization Behavior and Mechanical Properties of Az31b Alloy During the Hot-Rolling Process

Effect of heating rate on the recrystallization behavior and mechanical properties of a cold-rolled Zr702

Microstructural evolution and mechanical property of Cu‐Cr‐Zr‐ZrB2 composites subjected to cryorolling and aging treatment

Microstructure and properties evolution of Mg–2Y–0.6Nd–0.6Zr alloy rolled at room and liquid nitrogen temperature

Revealing the evolution mechanisms of microstructure, texture and mechanical behavior in Zr702 alloy plates fabricated by accumulative roll bonding

Formation Mechanism of Surface Gradient Microstructure and Mechanical Properties Evolution of Mg-Y-Nd-Gd-Zr Alloy by Ultrasonic Rolling

Microstructure, texture evolution and mechanical anisotropy of Mg-Gd-Y-Zn-Zr alloy sheets produced by unidirectional and cross rolling

Synergetic Strengthening of Grain Refinement and Texture in Gradient Zircaloy-4 by Surface Mechanical Rolling Treatment

Effect of ultrasonic surface rolling process on microstructure and properties of rolled Mg-Y-Nd-Zr alloy

Microstructure evolution behavior and mechanical mechanisms in a near α-Zr alloy by cold rolling

Reduction per pass effect on texture traits and mechanical anisotropy of Mg–Al–Zn–Mn–Ca alloy subjected to unidirectional and cross rolling

Microstructures and mechanical properties of Mg-6Gd-1Er-0.5Zr alloy sheets produced with different rolling temperatures

Study on Microstructures and Mechanical Properties of Layered and Layered‐Gradient Zr/Ti Materials

Effect of Zr on microstructure evolution of Ti-Mo composite microalloyed steel during rolling