Abstract:Diamond/Cu-Sn-Ti composites as potential superhard abrasives products have been successfully prepared by spark plasma sintering (SPS) at 1223 K. The different TiH 2 content on changes of wettability, phase composition, interface layer characteristics, such as reaction layer thickness and elemental distribution, and wear performance of bulk composites have been systematically studied. The results revealed that at 5wt.% TiH 2 content, all diamond grains were completely coated, showing sufficient wettability. In addition, an even thicker, more continuous, and uniform TiC layer have been generated at the interface, and the average thickness reaching a stable value of 1.72 μm, forming the strongest interfacial bonding strength. Whereafter, when content of TiH 2 increases to more than 5wt.%, coating morphologies and the homogeneity of reaction layer has no appreciable changes, indicating that the maximum extent wetting and interface reaction balance were achieved. However, excessive Ti may promote the formation of large amounts of brittle Cu 41 Sn 11 phase, which will significantly weaken metal matrix strength and then leading inferior wear resistance. The minimum weight loss obtained at 5wt.% TiH 2 content, and the main way of weight loss was the wear and crushing of diamond grains. Meanwhile, through FIB-TEM, confirmed that the interfacial reaction layer was mainly composed of continuous TiC layer adjacent to diamond and discontinuous TiC layer in the filler metal, and constitute the formation of a high strength metallurgical interfacial bonding layer.

Fabrication of Ti2AlC ceramic bonded diamond composites by self-propagation high temperature sintering

Effect of Sn and Si on the Synthesis of Ti<sub>3</sub>Al(Sn/Si)C<sub>2</sub> by Self-Propagating High-Temperature Sintering

Rapid fabrication of the Ti3SiC2 bonded diamond composite by spark plasma sintering

Reaction mechanism of Ti3SiC2 formed on the diamond

Fabrication of Cu/TiC Bonded Diamond Composite by Reaction Sintering

Reaction Mechanism of Ti<SUB>3</SUB>SiC<SUB>2</SUB> Formed on the Diamond

Effect of TiH2 Content on the Interfacial Reaction Layer Characteristics and Wear Resistance of Diamond/Cu-Sn-Ti Composites Prepared by Spark Plasma Sintering

Preparation of New Al Based Complex Bonded Diamond Composite

Preparation of Al–TiC Composites by Self-Propagating High-Temperature Synthesis

Investigation on NiAl–TiC–Al2O3 Composite Prepared by Self-Propagation High Temperature Synthesis with Hot Extrusion

Structure and Phase Composition of SHS Products in Powder Mixtures of Titanium, Carbon, and Aluminum

Al3Ti/Al composites prepared by SHS

Preparation of Ti3AlC2 and Ti2AlC by self-propagating high-temperature synthesis and study on the reaction mechanism

PREPARATION OF Ti3AlC2 AND Ti2AlC BY SELF-PROPAGATING HIGH-TEMPERATURE SYNTHESIS AND STUDY ON MECHANISM OF THE REACTION

Preparation of Diamond/aluminum Composite with Titanium Coating on Diamond Powder by Microwave Technology

Dense TiC-Al2O3 composites fabricated by SHS

Microstructures of TiC-Al2O3-Fe composites prepared by SHS/PHIP

Synthesis of diamond composites via microwave sintering and the improvement of mechanical properties induced by in-situ decomposition of Ti3AlC2

Self-Propagating High-Temperature Synthesis in a Ti−Al−C Powder System Using Different Carbon Precursors

Nano- and Submicron-Sized TiB2 Particles in Al–TiB2 Composite Produced in Semi-Industrial Self-Propagating High-Temperature Synthesis Conditions

Effects of Ti/Al Ratio on Formation of Ti-Al Intermetallics/TiB2 Composites by SHS from Ti-Al-B Powder Mixtures