Abstract:TiC + Al binder metal-matrix composites are fabricated by self-propagating high-temperature synthesis (SHS) in reaction power mixtures of titanium, carbon (ash), and aluminum. It is established that stable combustion in a steady wave mode is possible with a content up to 50 wt % aluminum powder in a reaction mixture. Crushing of synthesized loose cakes and subsequent sieve scattering gave composite powders with a cloddy shape close to equilibrium. This shape is favorable for good looseness, which is necessary when using powders for surfacing and sputtering of wear-resistant coatings. Synthesis products are investigated by scanning electron microscopy and X-ray structural (XRS) and energy-dispersive X-ray (EDX) analysis. It is established that the average size of carbide inclusions in the composite structure decreases monotonically with an increase in the content of the aluminum powder inert in the thermal aspect in reaction mixtures. The lattice parameter of titanium carbide determined by the XRS method turned out much smaller than known values for equiatomic-composition carbide. Herewith, no dependence of the lattice parameter on the aluminum content is found for composites. Carbide inclusions in the composite structure are investigated by the EDX method, and it is established that the titanium content corresponds to its concentration in equiatomic-composition carbide. In addition to titanium and carbon, carbide contains up to 2.5 wt % dissolved aluminum, which can affect the carbide lattice parameter.

Preparation of Al–TiC Composites by Self-Propagating High-Temperature Synthesis

In Situ Synthesis of Al–TiC in Aluminum Melt

Preparation of Ti 3 AlC 2 and Ti 2 AlC by self-propagating high-temperature synthesis

In situ fabrication of TiC particulates locally reinforced aluminum matrix composites by self-propagating reaction during casting

Al3Ti/Al composites prepared by SHS

Preparation of Ti3AlC2 and Ti2AlC by self-propagating high-temperature synthesis and study on the reaction mechanism

Self-Propagating High-Temperature Synthesis in a Ti−Al−C Powder System Using Different Carbon Precursors

PREPARATION OF Ti3AlC2 AND Ti2AlC BY SELF-PROPAGATING HIGH-TEMPERATURE SYNTHESIS AND STUDY ON MECHANISM OF THE REACTION

Rapid Synthesis of Bulk Ti2alc by Self-Propagating High Temperature Combustion Synthesis with A Pseudo-Hot Isostatic Pressing Process

In Situ TiC Ceramic Particles Locally Reinforced Al‐Si Matrix Composites Prepared by SHS‐Casting Method from the Al‐Si‐Ti‐C System

Structure and Phase Composition of SHS Products in Powder Mixtures of Titanium, Carbon, and Aluminum

Effect of Sn and Si on the Synthesis of Ti<sub>3</sub>Al(Sn/Si)C<sub>2</sub> by Self-Propagating High-Temperature Sintering

Investigation on NiAl–TiC–Al2O3 Composite Prepared by Self-Propagation High Temperature Synthesis with Hot Extrusion

Joining of TiAl Intermetallic by Self-Propagating High-Temperature Synthesis

Dense TiC-Al2O3 composites fabricated by SHS

Fabrication of Ti2AlC ceramic bonded diamond composites by self-propagation high temperature sintering

Self-propagating high temperature combustion synthesis of TiB/Ti composites

Reaction synthesis of Al/TiC composites and the effect of Al content

Study on process and phase constitute of SHS of AlTiC composite

Preparation of a hard AlTiVCr compositionally complex alloy by self-propagating high-temperature synthesis

Self-Propagating High Temperature Synthesis (SHS) of Intermetallic Compounds Titanium and Nickel Aluminides