Abstract:TiC + Al binder metal-matrix composites are fabricated by self-propagating high-temperature synthesis (SHS) in reaction power mixtures of titanium, carbon (ash), and aluminum. It is established that stable combustion in a steady wave mode is possible with a content up to 50 wt % aluminum powder in a reaction mixture. Crushing of synthesized loose cakes and subsequent sieve scattering gave composite powders with a cloddy shape close to equilibrium. This shape is favorable for good looseness, which is necessary when using powders for surfacing and sputtering of wear-resistant coatings. Synthesis products are investigated by scanning electron microscopy and X-ray structural (XRS) and energy-dispersive X-ray (EDX) analysis. It is established that the average size of carbide inclusions in the composite structure decreases monotonically with an increase in the content of the aluminum powder inert in the thermal aspect in reaction mixtures. The lattice parameter of titanium carbide determined by the XRS method turned out much smaller than known values for equiatomic-composition carbide. Herewith, no dependence of the lattice parameter on the aluminum content is found for composites. Carbide inclusions in the composite structure are investigated by the EDX method, and it is established that the titanium content corresponds to its concentration in equiatomic-composition carbide. In addition to titanium and carbon, carbide contains up to 2.5 wt % dissolved aluminum, which can affect the carbide lattice parameter.

In Situ Synthesis of Al–TiC in Aluminum Melt

Preparation of Al–TiC Composites by Self-Propagating High-Temperature Synthesis

In situ fabrication of TiC particulates locally reinforced aluminum matrix composites by self-propagating reaction during casting

Preparation of Ti 3 AlC 2 and Ti 2 AlC by self-propagating high-temperature synthesis

In-situ Synthesis of Nanocrystalline TiC Powders, Nanorods, and Nanosheets in Molten Salt by Disproportionation Reaction of Ti(II) Species

Preparation of Ti3AlC2 and Ti2AlC by self-propagating high-temperature synthesis and study on the reaction mechanism

In Situ Synthesis of Ti2AlC–Al2O3/TiAl Composite by Vacuum Sintering Mechanically Alloyed TiAl Powder Coated with CNTs

Self-Propagating High-Temperature Synthesis in a Ti−Al−C Powder System Using Different Carbon Precursors

Synthesis of Submicrometer-Sized TiC Particles in Aluminum Melt at Low Melting Temperature

In Situ TiC Ceramic Particles Locally Reinforced Al‐Si Matrix Composites Prepared by SHS‐Casting Method from the Al‐Si‐Ti‐C System

Synthesis of C F /tial 3 Composite by Infiltration-In Situ Reaction

Al3Ti/Al composites prepared by SHS

Rapid Synthesis of Bulk Ti2alc by Self-Propagating High Temperature Combustion Synthesis with A Pseudo-Hot Isostatic Pressing Process

Structure and Phase Composition of SHS Products in Powder Mixtures of Titanium, Carbon, and Aluminum

Microstructure and Compressive Properties Ofin SituSynthesized TiC/Ti Composites

Microstructure and property of Al/TiC composites prepared by reaction synthesis

A Review on In Situ Synthesis of Al/TiC and Al/SiC-Composites

PREPARATION OF Ti3AlC2 AND Ti2AlC BY SELF-PROPAGATING HIGH-TEMPERATURE SYNTHESIS AND STUDY ON MECHANISM OF THE REACTION

Microstructure and Phase Evolution Characteristics of the In Situ Synthesis of TiC-Reinforced AZ91D Magnesium Matrix Composites

Synthesis of TiCx/Al Composites via In Situ Reaction between AlxTi Melt and Dissolvable Solid Carbon

Microstructural Characterization of TiC in in Situ Synthesized Titanium Matrix Composites