Abstract:TiC + Al binder metal-matrix composites are fabricated by self-propagating high-temperature synthesis (SHS) in reaction power mixtures of titanium, carbon (ash), and aluminum. It is established that stable combustion in a steady wave mode is possible with a content up to 50 wt % aluminum powder in a reaction mixture. Crushing of synthesized loose cakes and subsequent sieve scattering gave composite powders with a cloddy shape close to equilibrium. This shape is favorable for good looseness, which is necessary when using powders for surfacing and sputtering of wear-resistant coatings. Synthesis products are investigated by scanning electron microscopy and X-ray structural (XRS) and energy-dispersive X-ray (EDX) analysis. It is established that the average size of carbide inclusions in the composite structure decreases monotonically with an increase in the content of the aluminum powder inert in the thermal aspect in reaction mixtures. The lattice parameter of titanium carbide determined by the XRS method turned out much smaller than known values for equiatomic-composition carbide. Herewith, no dependence of the lattice parameter on the aluminum content is found for composites. Carbide inclusions in the composite structure are investigated by the EDX method, and it is established that the titanium content corresponds to its concentration in equiatomic-composition carbide. In addition to titanium and carbon, carbide contains up to 2.5 wt % dissolved aluminum, which can affect the carbide lattice parameter.

Al3Ti/Al composites prepared by SHS

Preparation of Al–TiC Composites by Self-Propagating High-Temperature Synthesis

In Situal3ti–al2o3 Intermetallic Matrix Composite: Synthesis, Microstructure, and Compressive Behavior

Effects of Ti/Al Ratio on Formation of Ti-Al Intermetallics/TiB2 Composites by SHS from Ti-Al-B Powder Mixtures

Investigation on NiAl–TiC–Al2O3 Composite Prepared by Self-Propagation High Temperature Synthesis with Hot Extrusion

Effect of Sn and Si on the Synthesis of Ti<sub>3</sub>Al(Sn/Si)C<sub>2</sub> by Self-Propagating High-Temperature Sintering

Structure and Phase Composition of SHS Products in Powder Mixtures of Titanium, Carbon, and Aluminum

In Situ Synthesis of Al–TiC in Aluminum Melt

Formation of TiB2-MgAl2O4 Composites by SHS Metallurgy

Microstructures of TiC-Al2O3-Fe composites prepared by SHS/PHIP

Dense TiC-Al2O3 composites fabricated by SHS

Preparation of Ti/Al based nanophase composite powder by mechanical alloying

Self-Propagating High Temperature Synthesis (SHS) of Intermetallic Compounds Titanium and Nickel Aluminides

Preparation of Ti 3 AlC 2 and Ti 2 AlC by self-propagating high-temperature synthesis

Nano- and Submicron-Sized TiB2 Particles in Al–TiB2 Composite Produced in Semi-Industrial Self-Propagating High-Temperature Synthesis Conditions

Preparation of Ti3AlC2 and Ti2AlC by self-propagating high-temperature synthesis and study on the reaction mechanism

Mathematical and experimental investigation of the self-propagating high-temperature synthesis (SHS) of TiAl3 and Ni3Al intermetallic compounds

Self-Propagating High-Temperature Reductive Synthesis of TiB 2 -Al 2 O 3 Composite Powders

Self-Propagating High-Temperature Reductive Synthesis of TiB_2-Al_2O_3 Composite Powders

Preparation of ti-al based nanophase composite powder by mechanical alloying

PREPARATION OF Ti3AlC2 AND Ti2AlC BY SELF-PROPAGATING HIGH-TEMPERATURE SYNTHESIS AND STUDY ON MECHANISM OF THE REACTION