Abstract:Low temperature oxide formation is an important process in the fabrication of thin-film transistors (TFT) used in active-matrix liquid crystal displays. However, low temperature oxide is prone to have defects at the SiO2/polycrystalline–SiGe interfaces. We have recently developed a novel rf (radio frequency) plasma oxidation method for polycrystalline SiGe (poly-SiGe) materials. The poly-SiGe wafers are oxidized in an oxygen rf plasma with the samples electrically floating. That is, the sample voltage is the same as the sheath potential of the floating wall and is always negative with respect to the bulk of the plasma since electrons have higher mobility than ions. The slightly negative potential on the wafers attracts low energy oxygen ions from the plasma and the resulting damage on the wafers is thus lower than that induced by the more commonly used and energetic electron cyclotron resonance (ECR) source. No deliberate heating is applied during oxidation since the samples are heated spontaneously by the plasma, but the temperature is measured to be below 100 °C throughout the entire process. The oxidation rate is comparable to that of ECR plasma oxidation. Depth profiles are acquired by Auger electron spectroscopy and the interfaces are examined by x-ray photoelectron spectroscopy. The n-channel metal oxide silicon device fabricated on the as-grown gate oxide shows good electrical characteristics. The process is thus compatible with inexpensive large-area, low-temperature fabrication of TFTs on glass substrates.

Plasma Activation Assisted Low-Temperature Direct Wafer Bonding

Low Temperature Hydrophilic SiC Wafer Level Direct Bonding for Ultrahigh-Voltage Device Applications

Bonding of Aluminum Coated Silicon Wafers Based on Polypropylene Carbonate and As a Multi-Functional Sensor

Floating Low-Temperature Radio-Frequency Plasma Oxidation of Polycrystalline Silicon-Germanium

Mechanisms for room temperature direct wafer bonding

Oxides Formation on Hydrophilic Bonding Interface in Plasma-Assisted Inp/Al2o3/Soi Direct Wafer Bonding

Time‐Dependent Surface Properties and Wafer Bonding of O 2 ‐ Plasma ‐ Treated Silicon (100) Surfaces

Effect of Combined Hydrophilic Activation on Interface Characteristics of Si/Si Wafer Direct Bonding

Study of InP/SOI Wafer Bonding Based on Wet Surface Activation Treatment

Hybrid bonding of GaAs and Si wafers at low temperature by Ar plasma activation

III-V/Si wafer bonding using transparent, conductive oxide interlayers

A Simple Low-Temperature Glass Bonding Process with Surface Activation by Oxygen Plasma for Micro/Nanofluidic Devices

Wafer bonding technology and its applications in optoelectronic devices and materials

Investigation of Plasma Activated Si-Si Bonded Interface by Infrared Image Based on Combination of Spatial Domain and Morphology

Low-temperature Cu/SiO 2 hybrid bonding based on Ar/H 2 plasma and citric acid cooperative activation for multi-functional chip integration

Effect of NH4OH Treatment on Plasma‐Assisted InP/Al2O3/SOI Direct Wafer Bonding

A novel method of anodic bonding

Single-crystalline LiNbO3 Integrated Onto Si-based Substrates Via Ar Plasma-Activated Low-Temperature Direct Bonding

Low Temperature Direct InP/SOI Wafer Bonding Based on Hydrophilic/hydrophobic Treatment

Wafer bonding for microsystems technologies

A collective die to wafer bonding approach based on surface-activated aluminum-aluminum thermocompression bonding