Abstract:With the development of lighting industry, electronic ballasts bring convenience as well as electronic wastes. Besides, huge amount of power ratings and types increase the burden on designing ballasts and the possibility of mismatching. In this paper, a simple fluorescent lamp detection method for universal ballast is proposed based on measuring the filament resistances during preheating process. Moreover, varied preheating frequencies are used to make sure that the differences between the nearest lamps are obvious enough. The test results with a range of T8 and T5-HE lamps present the differences are evident to detect. In order to prevent ignition in detection process and ensure normal operation, the control strategy is carried out. As opposed to the conventional techniques, it doesn't need igniting the lamps. Thus, operating in improper power ratings could be avoided. Finally, the experimental results have validated the effect of the proposed method.

Analysis of the Key Points of the Glow-starters for Fluorescent Lamps Standard

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

A Digital Controlled Ballast for Metal Halide Lamp

Analysis and Design of Current Auxiliary Circuit for Automotive HID Lamp Ballast

Analysis and design of igniter for HID ballast

A fluorescent lamp model based on its physical characteristics

Investigation on Start-Up Characteristics of Automotive HID Lamps with Electronic Ballast

Analysis of the Voltage Feedback Self-Oscillating Electronic Ballasts

The Derivation of Fluorescent Lamp System Model and Calculation of its Key Parameters

Introduction of Safety Requirements for DC or AC Supplied Electronic Ballasts for High Intensity Discharge Lamps

An automatic fluorescent lamp detection method without igniting the lamps

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

A Timing Controllable and Polarity Tracked Igniter for High Intensity Discharge Lamp Electronic Ballast

Key Points for Attention in the Electricity and Thermology Design of Luminaires

Analysis of General Quality Problems of Self-ballasted Fluorescent Lamp Product Emerging in State Supervision and Inspection

Investigation On The Start-Up Of Low Wattage Metal Halide Lamp Controlled By Low-Frequency Square-Wave Ballast

Analysis of the HID Ballast's Advantages and Disadvantages and Its Improved Application

Electronic Ballast for Low Power High Pressure Sodium Lamp Based on Charge Pump Power Factor Correction Technique

LCLC resonant converter for multiple lamp operation ballast

Practical Submodule Capacitor Sizing For Modular Multilevel Converter Considering Grid Faults

Introductions of Some Types of Testing Devices for Lighting Equipments