Abstract:A transformerless zero-voltage switching (ZVS) megahertz interleaved inverter is proposed in this paper to improve the driving efficiency of dielectric barrier discharge (DBD) lamps. The proposed inverter consists of two inductors and two metal oxide semiconductor field effect transistors (MOSFETs). The MOSFETs operate in the interleaving mode and the energy injected into the DBD device is controlled by adjusting the turn-on time or frequency of the switching devices. Various waveforms can be realized by controlling the phase difference of the pulses. The operational principles were analyzed and the circuit was simulated. A prototype was built and demonstrated. Experiment results show that the proposed inverter can achieve ZVS and generate high-voltage bipolar pulses with a frequency range from several kilohertz to 1 MHz. A short pulse with a steep rise time of 40 ns, a peak-to-peak voltage of 1400 V and full width at half the maximum of 220 ns at a frequency of 1 MHz can be achieved. The lamp efficiency was increased by more than 7% when compared with the lamp driven at kilohertz. Therefore, it is suggested that the proposed inverter is suitable for driving the dielectric barrier discharge lamps efficiently with a simple structure.

A Timing Controllable and Polarity Tracked Igniter for High Intensity Discharge Lamp Electronic Ballast

A New Type of Controlled Igniter for Metal Halide Lamps

Improved Parallel Igniter for Electronic Ballast of HID Lamps

Analysis and design of igniter for HID ballast

A Digital Controlled Ballast for Metal Halide Lamp

A Novel Low-Cost High-Reliability Igniter for Metal Halide Lamps

Modeling and Analysis of A Novel Igniter for Hid Lamps

Analysis and Design of A New Hot-Striking Igniter for Hid Lamp

Investigation on Start-Up Characteristics of Automotive HID Lamps with Electronic Ballast

A Novel Zvs Double Switch Flyback Inverter and Pulse Controlled Dimming Methods for Flat Dbd Lamp

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

Megahertz ZVS Transformerless Interleaved Inverter for Dielectric Barrier Discharge Lamps

Electronic Ballast for MHL Based on ARM Microcontroller

New Control Strategy for a Two-Stage Low-Frequency Square-Wave Electronic Ballast for MHD Lamp

Study of Igniter in Low-Frequency Square Wave Electronic Ballasts for Metal Halide Lamps

Analysis and Design of Current Auxiliary Circuit for Automotive HID Lamp Ballast

A Novel Control Strategy for Instant Start-up of Low Wattage Metal Halide Lamp

Electronic Ballast for Automotive Lamp Using Simulation Control

New electronic ballast circuits for high intensity discharge lamps

Investigation On The Start-Up Of Low Wattage Metal Halide Lamp Controlled By Low-Frequency Square-Wave Ballast

Digital Eectronic Ballast for High Intensity Discharge Lamps