Abstract:Metal halide lamps have very serious acoustic resonance problem. The most widely used method to achieve acoustic-resonance free is low-frequency square-wave electronic ballast with an additional pulse igniter. Compared with high frequency resonance ignition, it needs more devices, such as sidac, thyristor, diac and so on, which increase the complexity and decrease the reliability of the igniter. This paper proposes a novel igniter without any extra switch device and feedback control circuit. High voltage ignition pulses can be obtained by utilizing the quick polarity inversion of output voltage of the full-bridge (FB) inverter. The location of the ignition pulse is just near the peak of the output voltage of the FB inverter, which is beneficial to the arc stability after the lamp starts up. Moreover, the igniter will not influence the steady-state operation of the lamp. Theoretical analysis and experiment results of a prototype for 70W MH lamps both have verified the effectiveness of the igniter.

Analysis and design of igniter for HID ballast

Modeling and Analysis of A Novel Igniter for Hid Lamps

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

A Timing Controllable and Polarity Tracked Igniter for High Intensity Discharge Lamp Electronic Ballast

Analysis and Design of Current Auxiliary Circuit for Automotive HID Lamp Ballast

Improved Parallel Igniter for Electronic Ballast of HID Lamps

Analysis and Design of A New Hot-Striking Igniter for Hid Lamp

A Digital Controlled Ballast for Metal Halide Lamp

A New Type of Controlled Igniter for Metal Halide Lamps

Electronic Ballast for MHL Based on ARM Microcontroller

Investigation on Start-Up Characteristics of Automotive HID Lamps with Electronic Ballast

Study of Igniter in Low-Frequency Square Wave Electronic Ballasts for Metal Halide Lamps

Electronic Ballast for Automotive Mercury Free HID Lamps Based on DSP

Design of a Digital Controller for High Frequency HID Lamp Ballast

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

A Novel Low-Cost High-Reliability Igniter for Metal Halide Lamps

Analysis of the Voltage Feedback Self-Oscillating Electronic Ballasts

Design for LCLC Resonant Inverter Circuit in High-power Electronic Ballast

Design of 400V/600W HPS Electric Ballast

Analysis of the HID Ballast's Advantages and Disadvantages and Its Improved Application

Analysis on a Novel Electronic Ballast for Low-wattage MH Lamp and Its Control Strategy