Abstract:Accurate and rapid analyses and simulation of semiconductor laser performance, such as small-signal modulation bandwidth, dynamic impedance and large-signal nonlinear distortion etc., are required for the optimal design of an optical communication system. In this paper, by introducing a novel normalized transformation for rate equations of semiconductor lasers, a compact rate-equation-based circuit model is presented and implemented in Agilent's advanced design system. Furthermore, the model is enhanced by including the current-voltage characteristics, and can be directly cascaded with extrinsic parasitic circuits for circuit- or system-level simulation. Thus, the model is applicable for optical transmission system performance evaluation and network characterization in both time and frequency domains.The steady-state and small-signal characteristics, such as current-photon density curve, current-voltage curve and input impedance, are predicted by this model. Two important dynamic characteristics of second-order harmonic distortion and two-tone third-order intermodulation products are simulated under different driving conditions. Fundamental sinusoidal signals at 1 GHz and 2GHz with peak-to-peak modulation current of 11.2mA and 18mA are used to investigate second-order harmonic distortion of semiconductor lasers. For the two-tone third-order intermodulation, two equal-amplitude sinusoidal signals at 4 GHz and 4.04 GHz, each with peak-to-peak modulation current of 11.2 mA, are used to examine the products at 3.96 and 4.08 GHz. The simulated results are compared to the published measurements results. Experiments show that the measured results agree well with the published data.

A fluorescent lamp model based on its physical characteristics

Simplified Modeling of the Power-electronized Load Based on Sensitivity Analysis

The Derivation of Fluorescent Lamp System Model and Calculation of its Key Parameters

A Low-order Simplified Model of Power-electronic-interfaced Loads

Modeling and Analysis of Electrodeless Lamp System

Concentric Multilayer Model of the Arc in High Intensity Discharge Lamps for Solar Simulators with Experimental Validation

Simulation the Impedance of Electrodeless Fluoresent Lamp

Measurement and Analysis of the Steady-state Impedance Characteristics of High-frequency Electrodeless Lamp

Model Analysis of 200 W RF Circular Induction Lamp and Equivalent Impedance Simulation Utilizing Orcad Software

Modeling and Analysis of A Novel Igniter for Hid Lamps

Analysis and design of igniter for HID ballast

Laboratory Model for Electric Arc Furnace Flicker and SVC Compensation Algorithm

Analysis of the Voltage Feedback Self-Oscillating Electronic Ballasts

LCLC resonant converter for multiple lamp operation ballast

Predictable Characteristics of the Fluorescent Lamp Electrodes with the Constant RMS Voltage Heating Method During the Preheating Phase

Phosphor Modeling Based on Fluorescent Radiative Transfer Equation.

Research on Improved Schwarz Arc Model Considering Dynamic Arc Length

A simplified thermal resistance network model for high power LED street lamp

Compact Circuit Modeling of Semiconductor Lasers for Analog Optical Link Simulations

Ultra-High-Power Arc Furnace Model for Low Frequency Non-Stationary Inter-harmonics

Modeling and Nonlinear Characteristics Analysis of Fluorescent Lamp Driven by a Full-Bridge Inverter