Abstract:Most countries begin to replace the conventional halogen headlamps with the small-wattage Xe metal halide lamp as the source of the automotive headlamp.However,the design of its electronic ballast is quite complex and the price is very high.As a result,it is only applied to the headlamp of the advance cars.This paper presentes the electronic ballast for automotive lamp using simulation control,and mainly discusses the basal principle and designing way including the basal structure of the ballast circuits and the selection of the topology of the main circuit.The transient process of the Xe lamp during the start-up phase is extremely complex.Therefore,how to complete the control of the start-up process is the difficulty.This paper also presentes the way of the constant power control and igniting.Based on the experimental data from the laboratory prototype,the circuits can complete all the control tasks from the phase of start-up to steady,including the switch of the constant power control,the high voltage of igniting.

Electronic Ballast for MHL Based on ARM Microcontroller

A Digital Controlled Ballast for Metal Halide Lamp

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

Electronic Ballast for Automotive Mercury Free HID Lamps Based on DSP

Power Control Strategy of Electronic Ballast for Metal Halide Lamps

Power Control Strategy of Electronic Ballast for HID Lamps

Digital Eectronic Ballast for High Intensity Discharge Lamps

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

Electronic Ballast for Automotive Lamp Using Simulation Control

Analysis and Design of Current Auxiliary Circuit for Automotive HID Lamp Ballast

A Two-Stage Low-Frequency Square-Wave Electronic Ballast for Metal Halide Lamps Using Peak-Current Control Mode

An adaptive acoustic resonance free electronic ballast for HID lamps

New Control Strategy for a Two-Stage Low-Frequency Square-Wave Electronic Ballast for MHD Lamp

Investigation On The Start-Up Of Low Wattage Metal Halide Lamp Controlled By Low-Frequency Square-Wave Ballast

LCLC resonant converter for multiple lamp operation ballast

A novel dimmable electronic ballast for HID lamps

A Novel Low-Frequency Electronic Ballast for HID Lamps

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

Design of 400V/600W HPS Electric Ballast

A Novel MHz Electronic Ballast with Three Order LPF

A Novel Control Strategy for Instant Start-up of Low Wattage Metal Halide Lamp