Abstract:Most countries begin to replace the conventional halogen headlamps with the small-wattage Xe metal halide lamp as the source of the automotive headlamp.However,the design of its electronic ballast is quite complex and the price is very high.As a result,it is only applied to the headlamp of the advance cars.This paper presentes the electronic ballast for automotive lamp using simulation control,and mainly discusses the basal principle and designing way including the basal structure of the ballast circuits and the selection of the topology of the main circuit.The transient process of the Xe lamp during the start-up phase is extremely complex.Therefore,how to complete the control of the start-up process is the difficulty.This paper also presentes the way of the constant power control and igniting.Based on the experimental data from the laboratory prototype,the circuits can complete all the control tasks from the phase of start-up to steady,including the switch of the constant power control,the high voltage of igniting.

Electronic Ballast for Automotive Mercury Free HID Lamps Based on DSP

A Digital Controlled Ballast for Metal Halide Lamp

Electronic Ballast for MHL Based on ARM Microcontroller

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

Analysis and Design of Current Auxiliary Circuit for Automotive HID Lamp Ballast

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

Digital Eectronic Ballast for High Intensity Discharge Lamps

Electronic Ballast for Automotive Lamp Using Simulation Control

Analysis on a Novel Electronic Ballast for Low-wattage MH Lamp and Its Control Strategy

Power Control Strategy of Electronic Ballast for HID Lamps

An adaptive acoustic resonance free electronic ballast for HID lamps

A HID Ballast System with DC Bus

Brief Analysis on Automotive Lamp Electronic Ballast

High-Dimming-Ratio New-type Automobile DRL HB LED Driver

Investigation on Start-Up Characteristics of Automotive HID Lamps with Electronic Ballast

Analysis of the HID Ballast's Advantages and Disadvantages and Its Improved Application

Investigation on start-up process of automotive HID lamps with digital platform

New Control Strategy for a Two-Stage Low-Frequency Square-Wave Electronic Ballast for MHD Lamp

Design of 400V/600W HPS Electric Ballast

Control Strategy of A Novel Two-Stage Acoustic Resonance Free Electronic Ballast for Hid Lamps