Abstract:To reduce the voltage stress on the switching device and improve the converter efficiency, a zero-voltage switching (ZVS) double switch flyback inverter is proposed. Moreover, two kinds of voltage pulse density modulation dimming methods with the double switch flyback inverter for the driving of flat dielectric barrier discharge (DBD) lamp were presented to improve the dimming performance of DBD lamp. The luminance of the DBD lamp was adjusted by controlling an adopted auxiliary switch. The dimming circuits were built and demonstrated. The luminance and luminous efficacy with variation of input power and dimming ratios were provided. The experiment results show that a ZVS was achieved with the proposed double switch flyback inverter and the flicker caused by the uncontrolled voltage oscillation during the turn-off time of dimming pulse could be reduced. Therefore, a wider dimming range about 100% to 2% could be achieved with the proposed method and the power consumption was reduced.

Digital Eectronic Ballast for High Intensity Discharge Lamps

A Digital Controlled Ballast for Metal Halide Lamp

Electronic Ballast for Automotive Mercury Free HID Lamps Based on DSP

Electronic Ballast for MHL Based on ARM Microcontroller

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

A novel dimmable electronic ballast for HID lamps

The Application of Digital Addressable Lighting Interface in HID Lamps' Electrical Ballast

Analysis on a Novel Electronic Ballast for Low-wattage MH Lamp and Its Control Strategy

Design of a Digital Controller for High Frequency HID Lamp Ballast

An adaptive acoustic resonance free electronic ballast for HID lamps

A Novel Zvs Double Switch Flyback Inverter and Pulse Controlled Dimming Methods for Flat Dbd Lamp

Power Control Strategy of Electronic Ballast for HID Lamps

New electronic ballast circuits for high intensity discharge lamps

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

A HID Ballast System with DC Bus

A Dimmable Electronic Ballast with Bi-frequency Control Based on T Type Filter

Dimmable UHF Electronic Ballast Based on T Type Filter

Electronic Ballast for Low Power High Pressure Sodium Lamp Based on Charge Pump Power Factor Correction Technique

A Novel Low-Frequency Electronic Ballast for HID Lamps

T- Filters Based Dual-Control Dimmable Electronic Ballast