Abstract:Most countries begin to replace the conventional halogen headlamps with the small-wattage Xe metal halide lamp as the source of the automotive headlamp.However,the design of its electronic ballast is quite complex and the price is very high.As a result,it is only applied to the headlamp of the advance cars.This paper presentes the electronic ballast for automotive lamp using simulation control,and mainly discusses the basal principle and designing way including the basal structure of the ballast circuits and the selection of the topology of the main circuit.The transient process of the Xe lamp during the start-up phase is extremely complex.Therefore,how to complete the control of the start-up process is the difficulty.This paper also presentes the way of the constant power control and igniting.Based on the experimental data from the laboratory prototype,the circuits can complete all the control tasks from the phase of start-up to steady,including the switch of the constant power control,the high voltage of igniting.

A Digital Controlled Ballast for Metal Halide Lamp

Electronic Ballast for MHL Based on ARM Microcontroller

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

Analysis on a Novel Electronic Ballast for Low-wattage MH Lamp and Its Control Strategy

Power Control Strategy of Electronic Ballast for Metal Halide Lamps

Electronic Ballast for Automotive Mercury Free HID Lamps Based on DSP

Power Control Strategy of Electronic Ballast for HID Lamps

A Digital Controller Based on Primary Side Regulation with Improved Accuracy for LED Application

Flexible-controlled high power-density automotive HID electronic ballast using full-digital control mode

New Control Strategy for a Two-Stage Low-Frequency Square-Wave Electronic Ballast for MHD Lamp

Design of a Digital Controller for High Frequency HID Lamp Ballast

A Two-Stage Low-Frequency Square-Wave Electronic Ballast for Metal Halide Lamps Using Peak-Current Control Mode

Digital Eectronic Ballast for High Intensity Discharge Lamps

A novel dimmable electronic ballast for HID lamps

A Novel Control Strategy for Instant Start-up of Low Wattage Metal Halide Lamp

Investigation On The Start-Up Of Low Wattage Metal Halide Lamp Controlled By Low-Frequency Square-Wave Ballast

Analysis and Design of Current Auxiliary Circuit for Automotive HID Lamp Ballast

Electronic Ballast for Low Power High Pressure Sodium Lamp Based on Charge Pump Power Factor Correction Technique

Application of Charge Pump PFC in Electronic Ballast for Metal Halide Lamp

A Novel Zvs Double Switch Flyback Inverter and Pulse Controlled Dimming Methods for Flat Dbd Lamp

Electronic Ballast for Automotive Lamp Using Simulation Control