Study of Igniter in Low-Frequency Square Wave Electronic Ballasts for Metal Halide Lamps

Rong Guo,Min Chen,Zhaoming Qian
DOI: https://doi.org/10.1109/tpel.2007.900450
IF: 5.967
2007-01-01
IEEE Transactions on Power Electronics
Abstract:Metal halide lamps (MHLs) have serious acoustic resonance problem. The most widely used method to achieve acoustic-resonance free is to use low-frequency square wave (LFSW) electronic ballasts. There are two ignition methods commonly used in LFSW electronic ballast: high-frequency resonance ignition and additional pulse igniter. This paper analyzed the problems during ignition while using the conventional additional pulse igniter and proposed some solutions. A novel high-frequency resonance igniter is also proposed, where no extra semiconductors and feedback control circuit are needed to perform the ignition. High-voltage ignition pulses are obtained by utilizing the fast polarity inversion of the output voltage of full-bridge inverter. Theoretical analysis, simulatio, and experiment results of a prototype for 70-W MHLs verified the effectiveness of both the proposed solutions and the igniter.
What problem does this paper attempt to address?