Abstract:With the development of lighting industry, electronic ballasts bring convenience as well as electronic wastes. Besides, huge amount of power ratings and types increase the burden on designing ballasts and the possibility of mismatching. In this paper, a simple fluorescent lamp detection method for universal ballast is proposed based on measuring the filament resistances during preheating process. Moreover, varied preheating frequencies are used to make sure that the differences between the nearest lamps are obvious enough. The test results with a range of T8 and T5-HE lamps present the differences are evident to detect. In order to prevent ignition in detection process and ensure normal operation, the control strategy is carried out. As opposed to the conventional techniques, it doesn't need igniting the lamps. Thus, operating in improper power ratings could be avoided. Finally, the experimental results have validated the effect of the proposed method.

Analysis of General Quality Problems of Self-ballasted Fluorescent Lamp Product Emerging in State Supervision and Inspection

Research on Load Characteristics of Energy-saving Lamp and LED Lamp

Analysis of Electronic Ballast for HID Lamps with Auxiliary Resonant Loop Protection

Risk Analysis of Photobiological Safety of LED Lighting Products

Brief Analysis on Automotive Lamp Electronic Ballast

Investigation on Start-Up Characteristics of Automotive HID Lamps with Electronic Ballast

The Environmental Performance of Fluorescent Lamps in China, Assessed with the LCA Method

The Identification and Improvement of the Application Standards of LED for Decoration Lighting and General Lighting Purposes and Its Ultimate Products

Analysis of the HID Ballast's Advantages and Disadvantages and Its Improved Application

Focusing on the Trend of the Development of LED Lighting Products Standards

Ecodesign Requirements of European Union for Fluorescent Lamps and Their Technical Answers

Researching Progress on Lifetime Evaluation Method of LED Lighting Products

The Identification and Application of the Main Safety Requirements in LED Controlgear Standards

An automatic fluorescent lamp detection method without igniting the lamps

Analysis of the Voltage Feedback Self-Oscillating Electronic Ballasts

Introductions of Some Types of Testing Devices for Lighting Equipments

The Comparison and the Developing Expectation of the Two-Stage Low-Frequency Square-Wave HID Electronic Ballasts

Analysis on the Resistance Insulation Test and Electric Strength Test of LED Luminaries and LED Control Gear

Analysis of the Healthy Lighting Product Design

A Study on Quality Management of Automatic Monitoring of Ambient Air

Lecture on Electrical Energy Quality I. Research Survey of Electrical Energy Quality