Abstract:Abstract Several coal-fired thermal power boilers with the same sub-critical parameters in Mengxi area of Inner Mongolia have successively suffered from cracking and leakage failure events of reheater connecting pipes, most of which occur at chamfered back tool grooves on the inner wall grooves of pipe welding joints. In order to find out the cause of cracking, typical failure samples were intercepted for macro-morphology, microscopy, SEM, chemical composition, mechanical properties, wall thickness measurement analysis and design and operation data investigation of several boiler equipment. The results show that comprehensive factors such as deviation of burning coal type from design of boiler, automatic dispatching of AGC load in power grid, low nitrogen combustion modification and so on cause changes in boiler combustion conditions and operation, which results in excessive high input level of reheater cooling water, resulting in long-term alternating thermal stress and non-periodic vibration of straight pipe and elbow arranged after fine-tuning of refrigerant flow direction in reheater. Finally, thermal fatigue cracks are induced to initiate and propagate through the stress concentration area of the chamfered knife groove of the inner wall of pipe welded joints.

FRACTURE ANALYSIS OF THE PIPES FOR EXCHANGING BOILER'S SURPLUS HEAT

Corrosion Failures of High Temperature Heat Pipes

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Cracking Analysis on Water Cooling Wall Pipe in Power Plant

FAILURE ANALYSIS OF BOILER TUBE

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Analysis on the cause of crack in connection pipeline of subcritical boiler reheater

Fracture Analysis of Tubes of Glyoxal Heat Exchanger

BURST ANALYSIS OF HIGH TEMPERATURE RE-HEATER PIPE OF POWERSTATION

Analysis on a Burst High-Temperature-Reheater Pipe in a Power Plant

Failure Analysis on Bursted High Temperature Steam Pipe of Heavy Oil Well

Microstructure and Property Analysis of Furnace Pipe Used over a Design Cycle

Corrosion failure analysis of the heat exchanger in a hot water heating boiler

Analysis of Superheater’s Pipe Wall Overtemperature by Fault Tree Diagnose

Cause analysis of elbow crack for header's connecting tubes of boiler's reheater concerning 300 mw unit

Failure Analysis on Water Wall Tube Burst of Heating Furnace

State analysis on reactor furnace pipe used over a design cycle

Failure Analysis of Abnormal Bulging and Cracking for High-Pressure Steam Pipe

SIMULATION AND ANALYSIS ABOUT WORN-OUT ON CONNECTING PIPE OF LOW-PRESSURE REHEATER FOR A BOILER OF 600 MW UNIT

ANALYSIS OF TEMPERATURE FIELD AND THERMAL STRESS FOR EXTERNALLY CONNECTED PIPE SOCKETS OF REHEATER BY USING THE FINITE ELEMENT METHOD

Failure Analysis of Collecting Pipe Head Used in Ammonia Refrigerating System