Abstract:Hydraulic expansion is commonly adopted for the tube to tubesheet expansion in the steam generator of nuclear power plants, and its quality greatly influences the stable and reliable operation of the steam generator. In this paper, an unexpected fracture of the hydraulic expansion mandrel occurred during the hydraulic expansion process, which caused the internal bulge defect (IBD) in the expanding area of the heat exchange tube. The corrosion test results showed that the IBD area had higher susceptibility to stress corrosion cracking (SCC) than the original tubes, which might lead to premature failure of the heat exchange tube in practical operation. To find out the root causes of this failure, the fracture morphologies of the hydraulic expansion mandrel were observed under the optical microscope (OM) and the scanning electron microscope (SEM), and the stress distribution during service were analyzed by mechanical calculation, The results indicated that the hydraulic expansion mandrel was repeatedly loaded by high-pressure medium during service, thus its weakest point was fractured due to high strain level and low cyclic number inelastic strain fatigue. Based on the results, the underlying mechanisms were discussed, and the countermeasures were proposed. The achievements of this paper provide theoretical and practical support for preventing similar failure and ensuring the expansion quality of the steam generator tubes for nuclear power plants.

Cracking Analysis on Water Cooling Wall Pipe in Power Plant

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Cause and mechanism analysis of cracking and leakage of water wall tube

Failure Analysis on Water Wall Tube Burst of Heating Furnace

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Analysis on a Burst High-Temperature-Reheater Pipe in a Power Plant

EXFOLIATION CRACKING ANALYSIS OF WATER-COOLING TUBE

FRACTURE ANALYSIS OF THE PIPES FOR EXCHANGING BOILER'S SURPLUS HEAT

Analysis on the cause of crack in connection pipeline of subcritical boiler reheater

Root Cause Analysis for Cracked Pipe in Auxiliary System in Nuclear Power Plant

Analysis on Cracking of a Pipeline Steel Pipe during Hydraulic Burst Test

Analysis and Repair of Cracks in Welding Tee of Main Steam Pipelines in Thermal Power Units

Fracture Failure Analysis on Bolt for Power Plant

Failure Analysis on Circulating Water Pump of Duplex Stainless Steel in 1000 MW Ultra-Supercritical Thermal Power Unit

Failure Analysis of Abnormal Bulging and Cracking for High-Pressure Steam Pipe

Cause analysis of elbow crack for header's connecting tubes of boiler's reheater concerning 300 mw unit

AXIAL CRACK ANALYSIS FOR THICK-WALL CENTRIFUGAL ROUGH PIPES

Failure Analysis on Unexpected Fracture of the Hydraulic Expansion Mandrel for Tube to Tubesheet Expanding in the Steam Generator of Nuclear Power Plant

Analysis on failure tube bundles of domestic air cooler used in hydrocracking unit

Failure Analysis on Abnormal Bursting of Heat Transfer Tubes in Spiral-Wound Heat Exchanger for Nuclear Power Plant

Investigation of Early Cracking of Dissimilar Metal Welds in a 1000-MW Ultra-supercritical Power Plant Close to the Sea