Abstract:Bimetallic composite pipe is composed of the outer layer (carbon steel or low alloy steel pipe) and the inner layer (high alloy corrosion-resistant steel pipe). Generally, when composite pipes can only be welded on one side due to their small diameter, high-alloy welding materials are usually adopted for the whole weld. In this case, the butt welding of L415/316L bimetal mechanical lined pipe adopts the welding sequence of sealing welding-root welding (inner layer)-transition welding-filler and cover welding (outer layer). In order to reduce welding material costs, low-alloy welding material E71T8-Ni1J is used for the outer layer. As a result, cracks at the mechanical joint between the inner layer and the outer layer after welding were found for Φ355 × (11 + 2)mm L415/316L bimetal mechanical lined pipe. Therefore, in this paper, optical microscope (OM) and electron probe micro-analyzer (EPMA) were used to analyze the weld microstructure and the element distribution near the crack, and the hardness of the welded joint was determined by Vickers hardness tester. Meanwhile, the finite element numerical simulation was used to analyze the residual stress near the mechanical joint between the inner and outer layers of composite pipes with different diameters. The results show that the pipe diameter affects the welding residual stress. The welding residual stress of Φ355 × (11 + 2)mm and Φ508 × (16 + 2)mm composite pipes is 301 MPa. There are two factors for the occurrence of cracks at the mechanical joint of Φ355 × (11 + 2)mm composite pipe. The mechanical factor is that the existence of stress concentration. The microstructure factor is the formation of lath martensite and upper bainite. The root cause of weld failure: the welding process was formulated or operated irregularly. The sealing welding layer should be originally austenite. Due to remelting, lath martensite and upper bainite are formed at the sealing welding layer.

Failure Analysis of Collecting Pipe Head Used in Ammonia Refrigerating System

Numerical Simulation and Safety Assessment Analysis for Pressure Pipe with Incomplete Penetration Defects

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Fracture failure analysis on Alloy783 bolts in medium-pressure valve bonnets of USC units

FAILURE ANALYSIS OF BOILER TUBE

FRACTURE ANALYSIS OF THE PIPES FOR EXCHANGING BOILER'S SURPLUS HEAT

Experimental and simulative failure analysis of reformer furnace outlet manifolds serviced in aromatic plant

Failure Analysis of High-Temperature Reformer Tube of Incoloy 800H in Synthetic Ammonia Installation

Failure analysis of L415/316L composite pipe welded joint

Failure Analysis on Water Wall Tube Burst of Heating Furnace

Failure Analysis on Cracking of a HMn58-2 Copper Cooler

Cracking Analysis on Water Cooling Wall Pipe in Power Plant

Failure Analysis on Pipes of Split Type Air-conditioner and Improvement Method

Fracture Analysis on A Cylindrical Shell Section of the Low-Pressure Absorption Tower

Analysis for a crack of the manhole in a reactor of Ethidene Diamine unit

Failure analysis on unexpected wall thinning of heat-exchange tubes in ammonia evaporators

Failure Analysis of Bursting on the Inner Pipe of A Jacketed Pipe in A Tubular Heat Exchanger

Failure Analysis of Abnormal Bulging and Cracking for High-Pressure Steam Pipe

Failure Analysis on Abnormal Leakage of Shell and Tube Heat Exchanger in Specialty Chemical Plant

Failture Analysis of Welded Joint on Superheater of a 670t/h Boiler

Failure Analysis of Leakage Occurred in Tee in Steam Pipeline Connected to Heating Furnace